Additional Safety Information - EINHELL TC-TS 2000 U Originalbetriebsanleitung

bench-type circular saw before you switch it on. Distractions
or possible jams can be dangerous.
g) Always use saw blades of the correct size and with a suita-
ble mounting hole (diamond-shaped or round). Saw blades
that do not match the mounting parts of the saw will not rotate
truly and will result in a loss of control.
h) Never use damaged or the incorrect saw blade assembly
material such as, e.g. fl anges, washers, screws or nuts. This
saw blade assembly material has been specially designed for
your saw, for safe operation and optimum performance.
i) Never get onto the bench-type circular saw and never use
the bench-type circular saw as a step stool. Serious injuries
could occur if the power tool topples over or if you come into con-
tact with the saw blade accidentally.
j) Make sure that the saw blade is fi tted in the correct direc-
tion of rotation. Do not grinding wheels or wire brushes
with the bench-type circular saw. If the saw blade is fi tted in-
correctly or accessories are used which are not recommended,
this could lead to serious injuries.

5) Additional safety information

1. Only use a saw blade which has the external diameter and hole
diameter specifi ed in the original operating instructions ("Techni-
cal data" section).
2. Use only blades with rotating speeds which are equal to or high-
er than the rotating speed marked on the power tool.
3. Use only a saw blade with a diameter which is the same as spe-
cifi ed on the saw.
4. Use the correct saw blade for the material you are working on.
5. Use only saw blades which are recommended by the manufactu-
rer which, if they are intended for cutting wood or similar materi-
als, comply with EN 847-1.
6. Only fi t blades which are well sharpened and have no cracks or
deformations.
7. Faulty saw blades must be replaced immediately.
Anl_TC_TS_2000_U_SPK9.indb 62 Anl_TC_TS_2000_U_SPK9.indb 62
GB
- 62 -
28.04.2020 14:40:09 28.04.2020 14:40:09