Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts; Carbon Brushes; Ordering Spare Parts And Accessories - EINHELL TE-MS 254 T Originalbetriebsanleitung

ard hood.
•
Always push the workpiece through to the
end of the splitter (40).
•
Switch off the saw by pressing the red button
„O".
•
The offcut piece will remain on the saw table
(37) until the blade (6) is back in its position of
rest.
•
Secure long workpieces against falling off at
the end of the cut! (Use e.g. a roller table.)
7.3.2 Cutting narrow workpieces (Fig. 37)
It is imperative to use a push stick (46) when ma-
king longitudinal cuts in workpieces smaller than
150 mm in width. A push stick is supplied with
this saw. Replace a worn or damaged push stick
immediately.
7.3.3 Cutting very narrow workpieces
(Fig. 38)
•
It is imperative to use a push block when ma-
king longitudinal cuts in very narrow workpie-
ces with a width of 50 mm and less.
•
There is no push block supplied with this this
saw! (Ask your our specialist dealer.)
•
Replace the push block without delay when it
becomes worn.
7.4 Transport (Fig. 1–4)
•
Fasten the turntable (12) with the locking
screw (15).
•
Adjust the machine head (1) so that it is
straight (0° on the scale (23)) and secure the
setting with the locking grip (22).
•
Set the saw to table mode (see 5.3).
•
To transport the machine, lift it by the trough
handles of the workpiece supports (19).
•
Never use safety devices such as the blade
guard or the stops far for handling or trans-
porting purposes.
•
Make allowance for the weight of the machine
and have a second person help you if requi-
red.

8. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
Anl_TE-MS_254_T_SPK13.indb 35
GB
9. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
9.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device im-
mediately each time you have finished using
it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.

9.2 Carbon brushes

In case of excessive sparking, have the carbon
brushes checked only by a qualifi ed electrician.
Danger! The carbon brushes should not be re-
placed by anyone but a qualifi ed electrician.
9.3 Maintenance
•
There are no parts inside the equipment
which require additional maintenance.
•
Lubricate all moving parts at regular intervals.

9.4 Ordering spare parts and accessories

Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.Einhell-Service.com
Tip! For good results we
recommend high-quality ac-
cessories from
www.kwb.eu
welcome@kwb.eu
- 35 -
!
10.05.2023 15:03:55