EINHELL TC-TS 2000 U Originalbetriebsanleitung Seite 82

Set the parallel stop (7) in accordance with the workpiece width
•
and height (see 7.3)
Carry out the cut in accordance with the workpiece width (see
•
8.1.1., 8.1.2.)
8.3 Making cross cuts (Fig. 25)
Slide the cross stop (21) into one of the grooves (21) in the table
•
and adjust to the required angle. (See 7.4.) If you also want to tilt
the blade (4), use the groove (21) which prevents your hand and
the cross stop from making contact with the blade guard.
Press the workpiece firmly against the cross stop (14).
•
Switch on the saw.
•
Push the cross stop (14) and the workpiece toward the blade in
•
order to make the cut.
Warning!
•
Always hold the guided part of the workpiece. Never hold the
part which is to be cut off.
Push the cross stop (14) forward until the workpiece is cut all the
•
way through.
Switch off the saw again. Do not remove the offcut until the blade
•
has stopped rotating.
9. Replacing the power cable
Danger!
If the power cable for this equipment is damaged, it must be repla-
ced by the manufacturer or its after-sales service or similarly trai-
ned personnel to avoid danger.
Anl_TC_TS_2000_U_SPK9.indb 82 Anl_TC_TS_2000_U_SPK9.indb 82
GB
- 82 -
28.04.2020 14:40:10 28.04.2020 14:40:10