EINHELL TC-TS 2000 U Originalbetriebsanleitung Seite 61

salignment of the kerf with the saw blade, and jamming and kick-
back.
i) Never saw several workpieces stacked one on top of the
other or one after the other. The saw blade could catch one or
more parts and cause kickback.
j) Do not start the saw if the saw is in the workpiece. If the saw
blade is jammed it may lift the workpiece and cause kickback
when the saw is restarted.
k) Keep the saw blades clean, sharp and adequately set. Ne-
ver use bent saw blades or saw blades with cracked or bro-
ken teeth. Saw blades which are sharp and properly set minimi-
ze jamming, blockages and kickback.
4) Safety information for the operation of bench-type circular
saws
a) Switch off the bench-type circular saw and disconnect it
from the mains power supply before you remove the table
insert, change the saw blade, adjust the splitter or the saw
blade safety guard and when the machine is left unatten-
ded. Precautions are intended to help prevent accidents.
b) Never leave the bench-type circular saw running unatten-
ded. Switch off the power tool and do not leave it before it
has come to a complete standstill. A saw which is left running
unattended is an uncontrolled danger.
c) Set the saw up at a location which is level and well-lit and
where you can stand steadily and keep your balance. The
location where you set it must provide suffi cient space for
you to handle your larger workpieces easily. Untidiness, unlit
work areas and uneven, slippery fl oors can lead to accidents.
d) Remove wood sawings and sawdust regularly from under
the saw table and/or from the dust extractor. Accumulations
of sawdust are combustible and can self-ignite.
e) Secure the bench-type circular saw. If the bench-type circular
saw is not properly secured, it could move or topple over.
f) Remove all adjusting tools, residual wood, etc., from the
Anl_TC_TS_2000_U_SPK9.indb 61 Anl_TC_TS_2000_U_SPK9.indb 61
GB
- 61 -
28.04.2020 14:40:09 28.04.2020 14:40:09