EINHELL TC-TS 2000 U Originalbetriebsanleitung Seite 80

be approx. 2 cm.
If necessary, slacken the two knurled screws (43) and adjust the
•
stop rail (24).
Retighten the knurled screws (43).
•
7.5 Setting the angle of the saw blade (Fig. 16)
Undo the locking grip (9).
•
To adjust the angle of the saw blade, press the hand wheel (8)
•
towards the machine and turn it at the same time until the pointer
(41) is aligned with the desired angular setting on the scale (42).
Secure the locking grip (9) again.
•
If needed, the end stop for adjusting the angle of the saw blade
•
can be readjusted for 0° and 45°. To do this, adjust the two ad-
justment screws (44) and (45).
8. Operation
Warning!
After every new adjustment we recommend you to make a trial
•
cut in order to check the new settings.
After switching on the saw, wait for the blade to reach its maxi-
•
mum speed of rotation before commencing with the cut.
Take extra care when starting the cut!
•
Never use the equipment without the suction function.
•
Regularly check and clean the suction channels.
•
8.1 Making longitudinal cuts (Figure 21)
Longitudinal cutting (also known as slitting) is when you use the
saw to cut along the grain of the wood. Press one edge of the work-
piece against the parallel stop (7) while the fl at side lies on the
saw table (1). The guard hood (2) must always be lowered over the
workpiece.
When you make a longitudinal cut, never adopt a working position
that is in line with the cutting direction.
Anl_TC_TS_2000_U_SPK9.indb 80 Anl_TC_TS_2000_U_SPK9.indb 80
GB
- 80 -
28.04.2020 14:40:10 28.04.2020 14:40:10