Additional Safety Instructions; Safety Measures - EINHELL TKS 1700 Bedienungsanleitung

Anleitung_TKS_1700_4340668:_
GB
10. Do not use the cable for purposes other
than that for which it is designed.
- Do not carry the tool by the cable and do
not use it to pull the plug out of the socket.
Do not carry the charger by the cable and
do not use is to pull the plug out of the
socket.
11. Secure the workpiece
– Use clamps or a vice to hold the
workpiece securely. This is safer than using
your hand, and also makes it possible to
use the machine with both hands.
12. Take care that your feet are a stable
distance apart
– Avoid abnormal working postures. Make
sure you stand squarely and keep your
balance at all times.
13. Take good care of your tools
- Keep your tools sharp and clean to keep
them working safely and efficiently. Observe
the maintenance instructions and the notes
about changing tools. Check the plug and
cable regularly, and if they are damaged,
have them replaced by a certified expert.
Check extension leads regularly and
replace these if damaged. Keep handles
dry, clean and free from oil and grease.
14. Pull the power plug
When not in use, before maintenance work
or when changing tools, such as saw blade,
drill and machine tools of any kind.
15. Always remove keys and wrenches
after use.
– Before switching on, make sure that all
keys and wrenches have been removed
from the tool.
16. Avoid unsupervised operation
- Never carry mains-powered tools with your
finger on the switch. Make sure the switch is
OFF when connecting the tool to the mains.
17. Outdoor use of extension cables
– For outdoor use, only use approved and
appropriately labelled extension cables.
18. Be alert at all times
- Observe your work. Work carefully. Never
use the electric tool when you are
distracted.
19. Check the appliance for damage
- Before using the equipment further, check
that safety equipment or slightly damaged
14
13.05.2009 14:04 Uhr Seite 14
parts are in good working order and function
correctly. Check that the moving parts are
working correctly, that they do not jam, and
that no parts are damaged. Make sure that
all parts are fitted correctly, to ensure that
the equipment remains safe to use.
Damaged safety devices and parts must be
repaired or replaced by experts in a
customer service workshop, unless
otherwise stated in the manual. Damaged
switches must be replaced by a customer
service workshop. Do not use equipment for
which the on-off switch does not correctly
function.
20. Important!
- For your own safety, only use accessories
and auxiliaries which are stated in the
operating instructions or which have been
recommended or indicated by the
manufacturer. Use of any other attachments
or accessories than those stated in the
operating instructions or in the catalogue
could lead to personal injury.
21. Repairs should only be done by an
expert
This electric tool complies with the pertinent
safety regulations. Repair work may only be
carried out by an electrician. Otherwise
there is a risk of accidents for the operator.
22. Attach the dust extraction system
- If there are apparatuses available for the
attachment of the dust extraction system,
make sure these are connected and used.

2.3 Additional safety instructions

2.3.1 Safety measures

Blades that are deformed or cracked must
not be used.
Replace worn out table inserts.
Use only blades which are recommended
by the manufacturer and comply with EN
847-1. When changing the blade, make
sure that the cutting width is not smaller and
the saw plate not bigger than the thickness
of the splitter.
Make sure that the chosen blade is suitable
for the material that is to be cut.
If necessary, wear suitable personal
protection equipment. This could consist of: