Herunterladen Diese Seite drucken

Ducati 96680241A Montageanleitung Seite 7

Werbung

A
Cod. ISTR - 591 ED./ED. 02
Condizione partendo dal sistema di
allarme NON inserito:
B
A sistema disinserito, (moto parcheggiata
senza allarme attivato) trascorso il periodo
di 36 ore il sistema entra in modalità Stand-
by. Non è più possibile inserire l'allarme
poiché il ricevitore è escluso e non vengono
generati allarmi in caso di urto, tentato furto
o accensione.
Per ripristinare tutte le funzionalità e attivare
poi l'allarme occorre accendere e spegnere
il quadro, non verranno emessi bip o suoni
di sistema e sarà possibile utilizzare
normalmente il sistema di allarme per altre
36 ore.
Condizione partendo dal sistema di
allarme inserto:
A sistema inserito, (allarme in sorveglianza
e lampeggio led), trascorse le 36 ore si
attiva la modalità Stand-by. In questa
condizione il ricevitore e il led deterrente
vengono disattivati. Rimane comunque
operativo e funzionante al 100% il circuito di
allarme. In caso di urto, tentato furto o
accensione del quadro scatterà l'antifurto e
interverrà la sirena ma solo dopo circa 8
secondi (segnalato con sequenza di bip
acustici).
Per disattivare invece l'allarme basterà
semplicemente accendere il quadro ed
azionare il telecomando entro 8 secondi.
Dopo la generazione dell'allarme tutte le
funzioni toneranno operative per altre 36
ore.
Nell'utilizzo quotidiano della moto l'allarme
non entrerà mai nella modalità Stand-by e
basterà avvicinarsi alla moto perché
l'antifurto possa essere attivato o
disattivato mediante il telecomando. Non
utilizzando la moto per piu di 36 ore invece
per attivare o disattivare l'antifurto
bisognerà girare la chiave per accendere il
quadro ed entro 8 secondi azionare il
telecomando.
Inserimento del sistema d'allarme:
Premere il tasto (A) del telecomando,
l'inserimento sarà confermato da:
- tre segnali acustici (beep);
- tre lampeggi delle luci di posizione;
- accensione del led sul cruscotto;
- attivazione dell'allarme acustico.
Disinserimento del sistema d'allarme:
Premere il tasto (A) del telecomando, il
disinserimento sarà confermato da:
- un segnale acustico (beep);
- un lampeggio lungo delle luci di
posizione;
- spegnimento led sul cruscotto;
- disattivazione dell'allarme acustico;
- segnalazione eventuale di allarme
avvenuto (luci di posizione e beep).
Condition with DISABLED alarm
system:
with disabled system, (parked motorcycle
with disabled alarm) after 36 hours the
system switches to Stand-by mode. It is no
longer possible to enable the alarm since
the receiver is disabled and no alarm is
triggered in case of impact, attempted theft
or switching on.
To restore all functions and enable the
alarm turn dashboard on and off; no beeps
or system sounds will be emitted and it will
be possible to use the alarm system as
usual for other 36 hours.
Condition with ENABLED alarm
system:
with enabled system, (enabled anti-theft
system and LED blinking), after 36 hours
the system switches to Stand-by mode. In
this condition receiver and relevant LED are
disabled. The alarm circuit remains
completely operative all the same. In case
of impact, attempted theft or dashboard
switching on, the anti-theft system will
trigger and after nearly 8 seconds the siren
will start (signalled by sequential beeps).
To disable the alarm turn on the dashboard
and use remote control within 8 seconds.
After the alarm has been triggered all
functions will be operative for other 36
hours.
During the motorcycle daily use the alarm
never enters in Stand-by mode and to
enable or disable the anti-theft system with
the remote control you will only have to go
near the motorcycle. If the motorcycle is
not used for more than 36 hours turn the
key to switch on the dashboard and use the
remote control within 8 seconds to enable
or disable the anti-theft system.
Arming the alarm system:
Press button (A) of the remote control, the
arming will be confirmed by:
- three acoustic signals (beep);
- three blinks of the parking lights;
- Dashboard LED switching on;
- warning buzzer activation.
Disarming the alarm system:
Press button (A) of the remote control, the
disarming will be confirmed by:
- one acoustic signal (beep);
- a single long flash of the parking lights;
- Dashboard LED switching off;
- warning buzzer deactivation;
- alarm tripped warning, if any, (parking
lights and beep).
Pag. - Page 7/12

Werbung

loading