Herunterladen Diese Seite drucken

Ducati 96680241A Montageanleitung Seite 33

Werbung

A
Cód. ISTR / Cod. ISTR - 591 ED./ED. 02
Condição partindo do sistema de
alarme NÃO ativado:
B
Com o sistema desativado, (moto
estacionada sem alarme ativado)
transcorrido o período de 36 horas, o
sistema entra no modo de Stand-by. Não é
mais possível ativar o alarme, já que o
receptor está desativado e não são gerados
alarmes no caso de colisão, tentativa de
roubo ou acendimento.
Para restabelecer todos os funcionamentos
e, em seguida, ativar o alarme, ocorre
acender e desligar o quadro, não serão
emitidos bips ou sons de sistema e será
possível utilizar normalmente o sistema de
alarme por mais 36 horas.
Condição partindo do sistema de
alarme ativado:
Com o sistema ativado, (alarme em
vigilância e led piscando), transcorridas as
36 horas é ativado o modo de Stand-by.
Nesta condição, o receptor e o led de
dissuasão são ativados. Em todo caso, o
circuito de alarme permanece 100%
operativo e em função. No caso de colisão,
tentativa de roubo ou acendimento do
quadro, o dispositivo anti-roubo será ativado
e a sirene intervirá, mas somente após
cerca de 8 segundos (sinalizado com
sequência de bips sonoros).
Ao contrário, para desativar o alarme
bastará simplesmente acender o quadro e
acionar o telecomando dentro de 8
segundos. Após a criação do alarme, todas
as funções voltarão a ser operativas por
mais 36 horas. Na utilização diária da moto,
o alarme nunca entrará no modo de Stand-
by e bastará aproximar-se da moto para que
o dispositivo anti-roubo possa ser ativado
ou desativado através do telecomando. Ao
contrário, não utilizando a moto por mais de
36 horas, para ativar ou desativar o
dispositivo anti-roubo será preciso girar a
chave para acender o quadro e dentro de 8
segundos, acionar o telecomando.
Ativação do sistema de alarme:
Pressione a tecla (A) do telecomando, a
ativação será confirmada por:
- três sinais sonoros (beep);
- três lampejos das luzes de presença;
- acendimento do led no painel de
instrumentos;
- ativação do alarme sonora.
Desativação do sistema de alarme:
Pressione a tecla (A) do telecomando, a
desativação será confirmada por:
- um sinal sonoro (beep);
- um lampejo longo das luzes de presença;
- desligamento do led no painel de
instrumentos;
- desativação do alarme sonora;
- eventual sinalização da ocorrência de
alarme (luzes de presença e bip).
Condition with DISABLED alarm
system:
with disabled system, (parked motorcycle
with disabled alarm) after 36 hours the
system switches to Stand-by mode. It is no
longer possible to enable the alarm since
the receiver is disabled and no alarm is
triggered in case of impact, attempted theft
or switching on.
To restore all functions and enable the
alarm turn dashboard on and off; no beeps
or system sounds will be emitted and it will
be possible to use the alarm system as
usual for other 36 hours.
Condition with ENABLED alarm
system:
with enabled system, (enabled anti-theft
system and LED blinking), after 36 hours
the system switches to Stand-by mode. In
this condition receiver and relevant LED are
disabled. The alarm circuit remains
completely operative all the same. In case
of impact, attempted theft or dashboard
switching on, the anti-theft system will
trigger and after nearly 8 seconds the siren
will start (signalled by sequential beeps).
To disable the alarm turn on the dashboard
and use remote control within 8 seconds.
After the alarm has been triggered all
functions will be operative for other 36
hours.
During the motorcycle daily use the alarm
never enters in Stand-by mode and to
enable or disable the anti-theft system with
the remote control you will only have to go
near the motorcycle. If the motorcycle is
not used for more than 36 hours turn the
key to switch on the dashboard and use the
remote control within 8 seconds to enable
or disable the anti-theft system.
Arming the alarm system:
Press button (A) of the remote control, the
arming will be confirmed by:
- three acoustic signals (beep);
- three blinks of the parking lights;
- Dashboard LED switching on;
- warning buzzer activation.
Disarming the alarm system:
Press button (A) of the remote control, the
disarming will be confirmed by:
- one acoustic signal (beep);
- a single long flash of the parking lights;
- Dashboard LED switching off;
- warning buzzer deactivation;
- alarm tripped warning, if any, (parking
lights and beep).
Pag. - Page 7/12

Werbung

loading