F) Mounting The Flight Control; G) Mounting The Piezo Gyro - Reely REX-X Pro Wichtige Informationen

f) Mounting the Flight Control System
Attention!
To operate the model, we recommend a brushless control with a constant current carrying capacity of at
least 35 A.
The flight control (1) is stuck on the front bottom board
with the help of the double-sided adhesive foam rubber
pad in line with the illustration.
Afterwards the motor cables are additionally secured with
a cable clip (2).
The receiver connection cable (3) is guided to the back
on the side in the chassis where the receiver is installed
later on.
To connect the flight battery, you have to solder on the
matching connection plugs of your preferred plug-type
connector system on the control feeds (4).

g) Mounting the piezo gyro

The Piezo gyro (1) is stuck onto the tailpipe support in line
with the illustration using a double-sided adhesive foam
rubber pad enclosed to the gyro.
The plug connection to the tail rotor servo (2) is secured
with strips of adhesive tape and the wound up cable
attached to the tailpipe with adhesive tape.
The connection cable (3) of the gyro is attached together
with the two servo cables with a cable clip (4) to the left
side of the chassis.
Figure 10
Figure 11
41