Checking The Engine Function - Reely Sky Hawk 2.0 Bedienungsanleitung

i) Checking the engine function
• Before you conduct a motor test, charge the flight battery and ensure that the model is held securely during the test.
Ensure that no loose objects such as paper or plastic films can be sucked in by the propeller.
• Keep objects and body parts away from the propeller under all circumstances.
• In order to perform the engine test, first activate the transmitter and then turn on the receiver unit on the model.
Attention important!
Before pushing the safety button at the model (see figure 10, pos. 6), ensure that the control lever for the
motor function is in the bottom position "Motor off".
If this is not the case, the propeller starts immediately when operating the safety switch and may cause
injuries. Damage to the model or similar is also possible.
• Once you have checked resp. corrected the position of the slider for the engine function, you can operate the safety
switch on the model.
• If you push the control lever for the engine function slowly upwards/forwards now, the rotor starts and the speed
increases depending on the position of the control lever. The maximum rotation speed is reached when the control
stick is on the top end.
• Perform a short engine test to check the control and cutoff behaviour of the motor. Then first turn off the receiver
unit and afterwards the transmitter.
50
Figure 18