Operation; Care Work; Adjusting The Sweeping Area - Kärcher MC 130 Plus Bedienungsanleitung

Operation

Control assignments for a vacuum sweeper with a 2-brush
sweeper system (pulled)
Note
The indicators in the switches light when the switches are
switched on.
Left joystick
1
– Joystick forwards: Lower the brush arms simultaneously
and switch on the side brushes
– Joystick backwards: Raise the brush arms simultaneously
and switch off the side brushes
– Joystick to the left/right: Pivot the brush arms simultaneous-
ly
Right joystick
2
Button is not used
Raise/lower suction mouth
3
Hydraulic system on/off
4
Button is not used
5
Button is not used
6
Water circulation function on/off (recycling water)
7
Suction fan on/off
8
ECO function
9
Switches the complete work program on.
PTO (side brushes, suction fan), fresh water, water circulation
(recycling water)
Water pump on/off
10
(A) Sweeping brush speed selection, common for the left-hand
and right-hand sides
(B) Button is not used
(C) Engine speed
Press to adjust the values
Note
The suction power depends on the set engine speed.
● 1600 rpm light waste
● 2200 rpm normal soiling
● 2500 rpm strong, heavy soiling
(D) Not used
(E) Left-hand and right-hand side brush contact pressure button
(F) Save button
Press to save adjusted values or programs
(G) Rotary knob
Press to change the adjusted values
94
Switching over to the 2-brush sweeping system (pulled):
1 Switch on the ignition.
2 Press F10 on the vehicle display.
3 Use F5 to select a pulled sweeper system.
A green bar in the display indicates a reduction in the brush con-
tact pressure.
A red bar indicates an increase in the brush contact pressure.
1 The existing lubrication points (grease nipples) are labelled.
Lubricate daily with multi-purpose grease.
2 Check the sweeping brushes for tangled cords and straps and
remove as necessary.
3 Keep the hydraulic connections clean and check for leaks
once a week.
4 Check the sweeping brushes for wear and damage and re-
place if necessary.

Adjusting the sweeping area

1. Adjust the sweeping area as shown in the illustration.
Right: 9 am- 2 pm
Right-hand side: 10 am- 3 pm
Adjusting the side inclination
Screw 1
1
Screw 2
2
2. Unscrew the screws.
3. Adjust the side inclination via the rotation point of screw 1.
4. Tighten the screws.
English
Brush contact pressure

Care work