Kärcher MC 130 Plus Bedienungsanleitung Seite 107

Topping up the engine oil
CAUTION
Danger of burns
Do not touch any hot surfaces such as engines, motors or gear-
boxes.
CAUTION
Risk of damage
An excessive high oil level leads to engine damage.
If the oil is above the "MAX" marking, drain oil until reaching the
correct oil level.
(1)Fuel tank fastener
(2)Fuel tank
1. Remove the left-hand side motor cladding.
2. Unscrew the fuel tank fastener screw and pivot the fuel tank
outwards.
(1)Filler cap
(2)MC 130 advanced plus filler cap
3. Check the engine oil level, see chapter Checking the engine
oil level.
4. Open the filler cap.
5. Top up the engine oil.
For the engine oil specifications, see chapter Technical data.
6. Do not fill the engine above the "MAX" marking.
7. Close the filler cap.
8. Check the engine oil level again after 5 minutes.
Top up the engine oil if necessary.
Replacing the engine oil filter
WARNING
Danger of burns
Allow the vehicle to cool down sufficiently before changing the
engine oil and engine oil filter.
Note
The engine oil is easier to drain when the engine is warm.
1. Switch off the engine.
2. Place a catch pan (min. 10 litres) underneath.
3. Unscrew the oil drain plug.
4. Unscrew the filler cap.
5. Drain oil.
6. Unscrew the oil filter.
7. Clean the mounting and sealing surfaces.
8. Coat the seal of the new oil filter with oil.
9. Screw in the oil filter and hand-tighten.
10.Screw in the oil drain plug (tightening torque 60 Nm).
11.Pour in the engine oil.
12.Close the filler cap.
13.Allow the engine to run for 30 seconds.
14.Wait 5 minutes.
15.Check the oil level.
Installation information
Renew the seals.
Check for leaks.
Air must be bled from the fuel system if the fuel tank has been run
empty of the fuel filter has been changed.
1. Fill the fuel tank.
2. Set the ignition switch to position I.
The pump runs audibly quieter after 2-5 minutes.
Side screws
1
Sweeping area
2
Side brushes
3
Nuts (4x)
4
Rear screws
5
1. Raise the side brushes.
2. Release the nuts.
3. Remove the side brush.
4. Fit the new side brush and screw in place.
Adjusting the sweeping area
Adjust the sweeping pattern according to the illustration using the
rear and side screws.
Flushing the water circulation system (option)
1. Disconnect the water circulation system hose coupling.
2. Connect the water supply hose to the water circulations sys-
tem and flush the system.
3. Set the irrigation switch to the water circulation system posi-
tion
The end of the suction pipe is better irrigated.
Empty the water reservoir
1. Open the valve on the drain hose (on the left under the waste
container).
2. Allow the water to drain.
English
Bleeding the fuel system
Replacing the side brush
107