Setting The Driver's Seat - Kärcher MC 130 Plus Bedienungsanleitung

6. Check the coolant level, see chapter Checking the coolant
level and topping up the coolant
7. Check the coolant for sufficient antifreeze if a danger of frost
exists
8. Check the electrical cables for damage
9. Check that all nuts and bolts are securely seated
10.Check the vehicle, engine and radiator grille for damage
11.Check the cleanliness of the engine air filter
12.Check the cleanliness of the cab dust filter
13.Check the fluid level in the windscreen washer reservoir, see
chapter Filling the wiping water container
14.Type pressures and tyre wear
In the vehicle
15.Ease of movement of the accelerator pedal
16.Are the working hydraulics (PTO) switched off?
17.With the ignition switched on: Do the charge indicator and oil
pressure warning lights light up?
Start the engine and check the following:
18.Do the charge indicator and oil pressure warning lights go
out?
19.Are the temperature indicator and fuel level indicator function-
ing?
20.Are the lighting system, travel direction indicator and flasher
system functioning correctly?
Safety checks on the vacuum sweeper
Note
Perform this safety check in addition to the device carrier safety
check.
Check the operational and traffic safety of the vehicle before driv-
ing.
1. Fastening of the waste container.
2. Check the hydraulic and electric connections to the device car-
rier.
3. Check the spray water connections to the sweeping system
and suction mouth.
4. Check the recycling water connection to the suction mouth
(option).
5. Check the spray water filling level at the fresh water tank.
6. Recycling water filling level in waste container (option).
7. Check the sweeping system and brushes for entangled cords
and tape.
8. Check the connections at the sweeping system and suction
mouth.
9. Check the fastening of the sweeping system and suction
mouth.
78

Setting the driver's seat

DANGER
Danger of accident
Only adjust the driver's seat when the device is standing.
Backrest with extension
1
Pull out for height adjustment
Backrest inclination adjustment
2
Horizontal adjustment - pull the lever upwards to adjust
3
Compressor switch - for air-cushioned seat (option)
4
Right arm rest height adjustment
5
Left arm rest side adjustment
6
Left arm rest length adjustment
7
Arm rest control panel
8
Document storage
9
Lumbar support adjustment
10
Seat belt
11
Horizontal shock absorber
12
1. Adjust the inclination, height and position of the left arm rest
for operating the control panel.
Note
The driver's seat is automatically damped.
English