Troubleshooting Guide; Vehicle Malfunctions - Kärcher MC 130 Plus Bedienungsanleitung

You can remedy minor faults using the following overview.
If in any doubt, please contact your authorised Customer Service.
DANGER
Risk of electric shock
Switch off the vehicle before carrying out any care and mainte-
nance work, and remove the key.
Malfunction
Vehicle does not start
Motor running irregularly
Engine is running, but the de-
vice does not drive or just
slowly
Motor does not switch off
(main switch to 0)
Dust when sweeping / insuffi-
cient suction power
Sweeping performance not
satisfactory
Activation of side brushes
not working
The side brushes are not run-
ning
Waste container emptying
does not work
Note
In case of all malfunctions not listed, contact Customer Service!
110

Troubleshooting guide

Vehicle malfunctions

Remedy
 Check / charge the battery.
 Switch on the main switch.
 Sit in the driver's seat (seat contact switch is activated).
 Set the driving direction lever to the NEUTRAL position - central position.
 Fill up fuel, bleed the fuel system.
 Check, clean and/or replace the fuel filter.
 Check the fuel connections and lines.
 Contact an authorised Customer Service department.
 Clean/replace the air filter.
 Check, clean and/or replace the fuel filter.
 Fill up fuel, bleed the fuel system.
 Check the fuel connections and lines.
 Contact an authorised Customer Service department.
 Release the parking brake.
 Check the position of the neutral lever.
 Have the oil level of the drive hydraulics checked by Customer Service.
 In the event of freezing temperatures and cold hydraulic oil: Allow the device to warm up for at least
3 minutes.
 Close the fuel cock at the fuel filter.
 Unplug the fuel supply pump.
 In the event of repeated occurrences, contact Customer Service.
 Empty the waste container.
 Switch on the suction fan.
 Check the hose on the suction fan.
 Check / replace the seals:
a Suction fan sealing collar.
b Filter chamber seal.
c Waste container seals.
 Check / clean / replace the dust filter.
a Check that the dust filter is firmly in place.
b In case of light soiling, clean the dust filter.
c In case of damage or heavy soiling, replace the dust filter.
 Check the sealing strips for wear / set / replace them.
 Check the roller brush and side brush for wear, replace them as necessary.
 Check the sealing strips for wear, replace them as necessary.
 Check that the coarse dirt flap is fully functional.
 Check that roller brush halves are correctly in place.
 Check the filling level of the hydraulic oil tank.
 Check the hydraulic system for leaks.
 Contact Customer Service.
 Check the filling level of the hydraulic oil tank.
 Check the hydraulic system for leaks.
 Check the side brushes for any tangled pieces of tape.
 Contact Customer Service.
Repair work and work on electrical components must only be per-
formed by your authorised Customer Service.
English