Care And Maintenance; General Notes; Service Indicator; Maintenance Intervals - Kärcher MC 130 Plus Bedienungsanleitung

Locking pin with safety bracket
1
Towing eye
2
Retaining pin with split pin
3
2. Attach the towing eye to the front of the vehicle frame.
3. Insert the retaining pin into the towing eye and secure with the
locking pin.
Towing the vehicle
CAUTION
Risk of damage due to incorrect towing
Only tow the vehicle away at walking speed.
Start up the towing vehicle slowly without jolting.
Fasten the towing rope or towing bar to the towing catch only.
Make sure the steering is working.
1. Release the parking brake spring actuator.
Bypass valves
1
2. Unscrew the bypass valves 3 revolutions (width across flats 24
mm).
3. Attach a towing bar or towing rope to the towing eye.
4. Pull the vehicle slowly onto the transporting vehicle.
5. Close the parking brake spring actuator and bypass valves.

Care and maintenance

General notes

DANGER
Crush hazard
When working under raised attachments, ensure these are al-
ways mechanically locked (shimming).
1. Before you clean and service the vehicle, or exchange parts or
adjust them to a different function, switch off the motor and re-
move the ignition key.
2. Check if your radio is secured with a radio code before discon-
necting the battery.
100
3. Disconnect the battery before working on the electrical sys-
tem.
4. Repairs may only be carried out by authorised customer ser-
vice centres or by qualified staff in this area who are familiar
with all relevant safety instructions.
5. Any welding work on the vehicle or attachments is only permit-
ted by authorised Kärcher Customer Service.
The service indicator lights up when the respective maintenance
needs to be done.
The service indicator flashes on the display:
● after 50 operating hours when the initial inspection needs to be
performed.
● Next service after 250 operating hours.
● Then every 500 operating hours.
Note
The service indicator must be reset by the Customer Service.
Note
In order to preserve warranty claims, all servicing and mainte-
nance work during the warranty period has to be performed by an
authorised Kärcher Customer Service, in accordance with the in-
spection check list.
● Daily before starting operation, see chapter Safety checks be-
fore startup.
● Lubricate all bearings after washing the vehicle.
● If necessary have the safety checks according to the applica-
ble local regulations performed by the Customer Service de-
partment.
● The intervals for inspection and maintenance work to be per-
formed by the customer are listed in the following table.
Additional maintenance work is to be carried out by the Cus-
tomer Service department in accordance with the inspection
checklist after 250, 500 (annually), 1000, 1500 or 2000 oper-
ating hours. Please inform the Customer Service department
in time.

Vehicle maintenance plan

Lubricate all bearings specified in the lu-
brication plan.
Check all Bowden cables and moving
parts for freedom of movement.
Check the side brushes and suction
mouth for wear and tangled pieces of
tape (for sweepers).
If the device has been operated with the
water circulation system switched off
(option), clean the filter and valve of the
water circulation system to ensure relia-
ble operation of the water circulation
system and prevent damage.
Check the rollers at the suction mouth
for freedom of movement (for sweep-
ers).
Check the spray pattern of the brush ir-
rigation spray nozzles and in the suction
mouth. Clean or replace the nozzles if
necessary (for sweepers).
Check all hoses and cable clamps.
Check the coolant hoses.
Clean the cooler fins on the water cool-
er, oil cooler and air-conditioning sys-
tem.
Check the V-belts and V-belt tension.
English

Service indicator

Maintenance intervals

Daily
(8h)
X
X
X
X
X
X
Weekly
X
X
X