Malfunction
The following coded error messages can occur when operating
the level V engines V2403-CR-TE4B-KRC-1 (MC 130 plus, MC
130 classic).
When an error is indicated while the engine is running, the indi-
cator lamp flashes and an error code may also be shown on the
display.
NCD error
Indicator lamp blinks
U0076
1Hz (one second interval) + on for 5 seconds +
1 Hz (one second interval) + on for 5 seconds ...
P0102
1Hz + on for 5 seconds + 1 Hz + on for 5 sec-
onds ...
Malfunction
U0076
P0102
P03014 / P1A28
P3015
P2455
Error messages for symbol displays
Cause
Coolant temperature is too high.
Hydraulic oil temperature too high.
Hydraulic oil temperature too low.
Engine oil pressure is too high.
Parking brake active.
Low fuel level.
Battery is not charging.
Regeneration process required.
Service required.
Coded error messages
Cause
No communication with exhaust gas recir-
culation
Air mass sensor not normal
Fault in the DPF system
No DPF function
Differential pressure sensor not normal
Remedy
Switch off the motor.
Clean the radiator (see chapter "Cleaning the radia-
tor").
Check the level of coolant in the motor, refill as neces-
sary.
If the warning light does not go out within 5 minutes:
a Switch off the engine
b Contact Customer Service
Operate the engine in idling mixture until the warning
light goes out.
Carefully warm up the engine until the warning light
goes out.
Call Customer Service.
Release the parking brake.
Top up the fuel.
Vent the fuel system if the tank was run dry.
Call Customer Service.
Perform regeneration (see chapter "Regeneration").
Have the device serviced by Customer Service.
a The service display must be reset by Customer Ser-
vice.
PCD Error
Indicator lamp blinks
P3014
1 Hz (1 second interval)
P1A28
1 Hz (1 second interval)
P3015
1 Hz (1 second interval)
P2455
1 Hz (1 second interval)
Remedy
Engine loses power and the exhaust emission perfor-
mance becomes worse
a Contact Customer Service
Engine loses power and the exhaust emission perfor-
mance becomes worse
a Contact Customer Service
Engine loses power and the exhaust emission perfor-
mance becomes worse
a Contact Customer Service
Engine loses power and the exhaust emission perfor-
mance becomes worse
a Contact Customer Service
No change in behaviour
a Contact Customer Service
English
111