During The First 50/100 Operating Hours (Running-In Period); Parking Brake; Setting The Heating, Ventilation And Air-Conditioner; Drive Mode - Kärcher MC 130 Plus Bedienungsanleitung

CAUTION
Reduced stability due to attachments
Adjust the driving style.
During the first 50/100 operating hours (running-in
● Drive the first 100 hours of operation gently and avoid over-
loading.
● Replace the engine oil, engine oil filter and hydraulic oil filter
after 50 operating hours (authorised Customer Service depart-
ment only).

Parking brake

The parking brake requires hydraulic pressure to release. The
brakes are automatically actuated when the engine is switched
off.
The parking brake is also applied when the engine is running and
the travel direction lever is in the NEUTRAL position.
Note
The "Parking brake applied" warning light in the multifunction dis-
play lights up when the parking brake is applied.

Setting the heating, ventilation and air-conditioner

Air fan controller
1
Air-conditioner controller (option)
2
Heating controller
3
1. Adjust the ventilation, heating and air-conditioner (option) us-
ing the 3 controllers.
Air recirculation lever
1
Ventilation nozzles
2
2. Adjust the volume and direction of the airflow at the ventilation
nozzles.

Drive mode

Start motor
The main switch must be switched on.
1. Sit down on the driver seat and fasten the seat belt.
2. Insert the ignition key into the ignition lock.
3. Set the travel direction lever into central position (neutral posi-
tion).
4. Turn on the ignition.
80
period)
Warning lights for charge control and motor oil pressure must
be on.
5. Start the motor.
Warning lights for charge control and motor oil pressure must
go out; if not, switch off the motor and rectify the error.
6. At ambient temperatures below 0 °C: Warm up the vehicle at
a low motor speed until the "Hydraulic oil temperature too low"
warning light goes out.
Selecting the travel direction
Travel direction selector switch
1
1. Press the travel direction selector switch towards the steering
wheel and in the desired travel direction.
The travel direction is shown in the display.
2. Bring the travel direction selector switch into the middle posi-
tion (neutral position).
The engine idles.
3. Press the travel direction selector switch to the end position.
4. Select the transport speed (between tortoise 20 km/h and hare
40 km/h).
The symbols are shown in the display.
5. Regulate the travel speed using the accelerator pedal.
ATTENTION
The vehicle must be at a standstill and the travel direction selec-
tor switch in the neutral position before changing the travel
speed.
Operating error
If the travel direction selector switch is in the forwards or reverse
position when changing speed, the tortoise/hare symbol on the
display will change but the travel speed will not switch over.
WARNING
Risk of accident
Do not drive while the waste container is raised.
CAUTION
Risk of accident
Do not let go of the accelerator pedal abruptly during driving. The
vehicle will be braked when the accelerator pedal is released.
The vehicle will be decelerated to a lesser extent when the accel-
erator pedal is released in transport mode rather than in operat-
ing mode.
CAUTION
Risk of damage
Make sure that the vehicle does not become stuck when driving
over obstacles.
Drive over obstacles up to 150 mm slowly and carefully at an an-
gle of 45°.
Obstacles above 150 mm may only be driven over using a suita-
ble ramp.
English
Driving