Waste Container - Kärcher MC 130 Plus Bedienungsanleitung

Calculation of the minimum front ballast for rear-mounted
attachments
1. Enter the result into the table.
Calculation of the minimum rear ballast for front-mounted
attachments
See the manufacturer's specifications for the value "x" or use a
value of x = 0.45 if no specifications are available.
1. Enter the result into the table.
Calculation of the actual front axle load
1. If the necessary minimum front ballast weight (GV min) is not
reached with the front attachment (GV) then the weight of the
front attachment must be increased to the minimum front bal-
last weight.
2. Enter the actual calculated permissible front axle load and the
permissible front axle load specified in the work machine op-
erating instructions into the table.
Calculation of the actual total weight
1. If the necessary minimum rear ballast weight (GH min) is not
reached with the rear attachment (GH), then the weight of the
rear attachment must be increased to the minimum rear bal-
last weight.
Calculation of the actual rear axle load
1. Enter the result into the table.

Waste container

Attaching the waste container
DANGER
Risk of crushing when lowering/raising the waste container
Maintain sufficient clearance to the waste container and the roll-
ers on the parking supports.
Maintain sufficient clearance to hazard zone and stop raising/
lowering immediately when a person enters the hazard zone.
ATTENTION
Risk of injury and damage
The dirt receptacle and fresh water tank are empty.
Remove the waste container only on a level and smooth surface.
88
Front parking support
1
Rear parking support
2
Lever for securing the parking supports
3
Retaining clip
4
1. The waste container must be secured on the parking supports
for installation.
2. Set the switchover valve to the attachment frame position.
3. Drive the rear of the vehicle carefully under the waste contain-
er.
4. Raise the attachment frame slowly until under the waste con-
tainer.
Hooks
1
Attachment frame
2
5. Hook the waste container onto the attachment frame using the
retaining hooks.
6. Continue raising the attachment frame until the load on the
front parking supports is relieved.
a Lift the attachment frame only until the rollers of the front
parking supports are approx. 20 mm in the air.
7. Pull out the front parking supports. For this, pull the retainer to
unlock and then press the lever.
8. Completely lower the attachment frame together with the
waste container.
9. Pull out the rear parking supports. For this, pull the retainer to
unlock and then press the lever.
English