Denon AVR-550SD, SYS-550SD Bedienungsanleitung Seite 23

• After adjusting using the test tones, adjust the channel levels either according to the playback sources or to
suit your tastes, as (described) below.
1
Select the speaker whose
level you want to adjust.
(Remote control unit)
The channel switches as shown below each
time the button is pressed.
FL C FR SR SB
FADER SW SL
NOTE:
• Please make sure the "AUDIO" position of
the slide switch on the remote control unit.
• If the channel levels are adjusted separately
after adjusting the fader, the fader adjustment
values are cleared, so adjust the fader again.
2
Adjust the level of the
selected speaker.
(Remote control unit)
Default setting of channel level is 0 dB.
The level of the selected speaker can be
adjusted within the range of +12 to –12 dB
using the cursor buttons.
SW channel level can be turned off by
decreasing one step from –12 dB.
OFF ´ –12 dB ´ 12 dB
Dolby Digital mode (only with digital input) and DTS Surround (only with digital input)
1
2 2
1
2
3
When the SIGNAL DETECT indicator is lit, we
recommend turning the surround back channel
using the SURROUND BACK button on the remote
control unit during playback.
To use DTS 96/24 sources with the optimum
system, we recommend turning the surround back
channel off.
Select the input source.
Playback with a digital input
q Select an input source set to digital
(COAXIAL/OPTICAL) (see page 14).
Example: DVD
FUNCTION / SELECT
(Main unit) (Remote control unit)
w Set the input mode to "AUTO", "PCM" or
"DTS".
(Remote control unit)
Select the Dolby/DTS Surround mode.
DOLBY/DTS
SURROUND
(Main unit) (Remote control unit)
When performing this operation from the main
unit's panel, press the SURROUND MODE
button, then turn the SELECT knob and select
Dolby Pro Logic II or DTS NEO:6.
FUNCTION / SELECT
SURROUND MODE
(Main unit) (Main unit)
Play a program source with the ,
• The Dolby Digital indicator lights
Light
when playing Dolby Digital sources.
• The DTS indicator lights when
Light
playing DTS sources.
• The SIGNAL DETECT indicator lights
Light
when playing 6.1-channel surround
sources containing the identification
signal.
2 2
1
2
1
5
4, 7
6
6
3
5
1
mark.
Operate the SURROUND BACK button to switch
Surround Back CH ON/OFF.
Light
(Remote control unit)
• Lights when the SURROUND BACK button is on.
ENGLISH
23