Werbung
Verfügbare Sprachen
Verfügbare Sprachen
© Fine adjustment (1)
1. By using the bladed screwdriver, tighten the setscrew
3. Looking
at the
envelope,
adjust
the height
of the
of the guide roller half its full turn, but as firmly as
guide
roller
making
the
tape
run
along
the
drum
possible.
lead.
If the cassette tape is kept loose, or close to the
2. Triggering the output signal with switching pulses,
helical lead position, the waveforms (envelopes) will
observe its envelope.
See Fig. 75-A.
arise as shown in Figs. 75-B and -C.
Switching pulse
—--
CH-2
|CH-|
(Waveform with switching pulse triggered)
Figure 75-A
a. In the case
where
the cassette tape is kept loose
above
the helical lead position, the envelopes will
be as shown below.
De
P
Figure 75-B
Supply side
(Drum''s entry)
Take up side
(Drum's outlet)
63
Werbung
