Werbung
Verfügbare Sprachen
Verfügbare Sprachen
@ (XRESJ20-04000)
—@ (XRESJ20-04000)
Clearance adjusting-
=
e) Clearance adjusting washer —
washer
Supply reel disk
Take-up reel disk
3) (NDAIV1009GEZZ)
(NDAIV1010GEZ2Z)
Height adjusting washer
5
{xwezs1 02054
ay
Counter belt
XWHJZ31 -05054
;
XWHJZ31-01054
(NBLTMOOO6GE00)
6) Reel disk thrust bearing
(NBRGM
0004GEZZ)
Height adjusting washer
¢
| XWHJZ31-02054
Reel disk shaft
} XWHJZ31-05054
XWHJZ31-01054
Reel disk shaft
©
Figure 53.
® Assembly
© Height Adjustment
* Supply reel disk:
1. Place the master plane and insure that the height of
1. Set the reel disk thrust bearings
©
, with due care
the reel disk is lower
than the part "'A"' but higher
paid to their direction.
than the part "B" of Fig. 53, by using the reel disk
2. Set the height adjusting washer ©) .
height adjusting jig.
If the height is not correct use
3. Replace supply reel disk.
the height adjusting washer: this washer is available in
4. Set the clearance adjusting washer @) .
three
sized
(3.1W
5.4—0.25),
(3.1W
5.4—-0.5)
and
5. Set the E-ring ).
(3.1W
5.4—0.13).
The looseness
in backlash
on the
6. Set the tension band.
shaft should not exceed 0.1 to 0.5mm.
Note:
2. For details of setting the master plane, see the previous
Be sure to test the height of the reel disk.
article P. 45.
* Take-up reel disk:
Note:
1. Set the height adjusting washer ©) .
Whenever
replacing
the reel disk perform the height
2. Replace take-up reel disk.
adjustment.
3. Set the clearance adjusting washer @ :
4. Set the E-ring@.
5. Set the counter belt.
Be sure to test the height of the reel disk.
Note:
1. Take care not to damage the reel shaft's surface with
the E ring.
2. Check that the reel disk can rotate smoothly if moved
by hand.
-
3. Take care not to bend the brake lever.
46
Werbung
