weinor Sottezza II Stretch/LED Austauschanleitung Seite 37

7. Stick a strip of double-sided adhesive tape (approx. 20 to 50 cm long) to the area under the
Optinut roller tube's fabric rail on each side of the fabric edges. Do not remove the double-
sided adhesive tape's protective film yet.
8. Hang the new fabric in the roller tube groove (1) and insert or press the fabric into the groove
using a blunt, flat tool (e.g. a plastic card) (2).
Note: The claw or magnetic claw piping hook and beaded profile with round cord edges must
be facing downwards (3). Align the roller tube in the centre (4)!
9. Secure the fabric on the projection profile with the cord edge and screw it back in place with
the 6x50 chipboard screw and fabric dowel.
10. Remove the double-sided adhesive tape's protective film and press the fabric onto it. Slight
corrections are still possible, as full adhesion is only achieved later.
11. Connect the test run cable and press the retract button until the fabric is wound up so far on
the Optinut roller tube shaft and the projection profile is still approx. 30 cm in front of the
cassette. As you do this, make sure that the fabric is wound up evenly and centrally.
12. Fold up the bottom of the cassette when
everything is working properly and make
sure that the straps are placed towards the
back in the headplates (Detail A).
13. Screw the two parts of the headplates
together with the M4 cylinder screws using
a socket wrench.
14. Chapter 3.5 "Inserting the tensioning
rope after changing the fabric" describes
how to tighten the system again.
15. Perform a test run as described in the
assembly instructions.
16. Align the system according to the assembly
instructions.
17. Re-fit the bracket covers to the brackets.
18. Close the projection profile again.
Reprogram the end position, if required.
PLEASE NOTE:
Insert the LED cover profile if it is missing
before the system is completely retracted.
Sottezza II Stretch/ LED/ Sottezza II OptiStretch/ LED
Technische Änderungen vorbehalten/ Technische wijzigingen voorbehouden/
We reserve the right to make technical changes/ Sous réserve de modifications techniques
A
Version/ Versie 1 13.01.2021
Artikelnummer/ Item
Number/ Numéro d'article 127266-0000 Page 37/55
Seite
Bladzijde