Positioning Guide Arms; Positioning The Welding Torch - Abicor Binzel ABICAR ADVANCED 42V Originalbetriebsanleitung

6 Putting into operation

6.3 Positioning guide arms

Fig. 7
A Component
B Guide arm, rear
C Knurled screws
A
E
C
In order to ensure restricted guidance along the contact surface, the guide arm (E) must be adjusted so that
it is shorter than the guide arm (B). The adjustment depends on the direction of movement and the length of
the guide arm. The difference should be approx. 10 mm for a straight component.
Loosen the knurled screw (C) and advance by 10 mm or one groove.
1
Retighten the knurled screw (C).
2

6.4 Positioning the welding torch

The cross slide must be adjusted according to the welding torch type and diameter. The welding torch
position can be changed in the vertical and horizontal direction during welding using the cross slide.
Fig. 8
A Adjusting screw, vertical
B Bracket, horizontal
A
D
► Turn the adjusting screws (A) and (C) of the cross slide to the left or right.
The brackets (B) and (D) can be adjusted sidewise, or downwards and upwards.
EN - 16
Adjustment of restricted guidance
Travel direction
Adjusting the cross slide
D Angle of approach
E Guide arm, front
Contact surface of the component
C Adjusting screw, horizontal
D Bracket, vertical
B
C
ABICAR ADVANCED 42V
B
C
D