Operating Instructions - Wilo Stratos GIGA Einbau- Und Betriebsanleitung

en
Info menu
Service menu
Error acknowledgement menu
Access disable menu
11.6

Operating instructions

11.6.1 Adjusting the setpoint
1.0.0.0
12.3
2200
1.0.0.0
1800
Fig. 39: Entering the setpoint
11.6.2 Changing to menu mode
132
• <4.0.0.0>: Pump parameter display
The menu <4.0.0.0> and its sub-menu elements show measuring data, device data, operat-
ing data and current statuses.
• <5.0.0.0>: Access to pump parameter settings
The menu <5.0.0.0> and its sub-menu elements provide access to basic system settings for
commissioning. The sub-elements are write-protected as long as service mode is not activ-
ated.
• <6.0.0.0>: Error acknowledgement
If an error occurs, the display shows the error page. Pressing the operating button takes you
from the error page to the error acknowledgement menu. After a waiting period has elapsed,
pending fault messages can be acknowledged. For additional information, see "Acknow-
ledging errors" chapter.
For additional information, see "Faults, causes and remedies" chapter
• <7.0.0.0>: Access disable
The "access disable" feature is available when DIP switch 2 is set to ON. The menu cannot be
reached via normal navigation.
Pressing the operating button activates or deactivates the access disable feature. The selec-
tion is confirmed by pressing the operating button.
The setpoint can be adjusted on the status page.
• Turn the operating button.
The display changes to menu <1.0.0.0> and the setpoint starts flashing. Turning the oper-
ating button increases or decreases the setpoint.
RPM
• To confirm the change, press the operating button.
The new setpoint will be accepted and the display will return to the status page.
RPM
To change to the menu mode:
2 s
• While the display is showing the status page, press the operating button for
2 seconds (except in event of a fault).
Installation and operating instructions • Wilo-Stratos GIGA, Wilo-Stratos GIGA B • Ed.01/2023-05
CAUTION
Risk of material damage!
Incorrect changes to settings can lead to pump operation errors, which in
turn can lead to pump or system damage.
• Settings in service mode should only be made during commissioning
and only by qualified personnel.
CAUTION
Risk of material damage!
Acknowledging faults without eliminating their cause can cause further
faults. Material damage may occur to the pump or system.
• Only acknowledge errors after they have been rectified.
• Only allow qualified personnel to rectify faults.
• If in doubt, consult the manufacturer.