Certificates And Approvals; Documentation - Endress+Hauser iTEMP HART TMT162 Bedienungsanleitung

Technical data
100
Terminals
2
2.5 mm (12 AWG) plus wire end ferrules
10.0.7

Certificates and approvals

CE mark
The measurement system fulfils the requirements demanded by the EU regulations.
Endress+Hauser acknowledges successful unit testing by adding the CE mark.
MTBF
147 a according to Siemens Standard SN29500
Ex approval
Information about currently available Ex versions (ATEX, FM, CSA, etc.) can be supplied by
your E+H Sales Center on request. All explosion protection data are given in separate
documentation which is available upon request.
Other standards and guidelines
• IEC 60529:
Degrees of protection by housing (IP-Code)
• IEC 61010:
Safety requirements for electrical measurement, control and laboratory instrumentation.
• IEC/EN 61326-series:
Electromagnetic compatibility (EMC requirements)
• NAMUR
Standardization association for measurement and control in chemical and pharmaceutical
industries. (www.namur.de)
• NEMA
Standardization association for the electrical industry.
CSA GP
CAN/CSA-C22.2 No. 61010-1, 2nd Edition
Marine approvals
For the type approval certificates (DNVGL, BV etc.) currently available, please contact your
Endress+Hauser Sales Center for information. All data relating to shipbuilding can be found
in separate type approval certificates which can be requested as needed.
UL approval
UL recognized component (see www.ul.com/database, search for Keyword "E225237")
10.0.8

Documentation

• Installation manual configuration software FieldCare (BA 031S/04/a4)
• Ex supplementary documentation:
ATEX II2(1)G: XA 020R/09/a3
ATEX II2G, EEx d: XA 031R/09/a3
ATEX II2D: XA 032R/09/a3
ATEX II1G: XA 033R/09/a3
ATEX II1/2GD: XA065R/09/a3
• Control Drawings:
FM IS 51005925
FM XP and DIP 51005926
TMT162
Endress+Hauser