Endress+Hauser iTEMP HART TMT162 Bedienungsanleitung Seite 82

Commissioning
Available in ReadWin ® 2000, HART
Commuwin II with Matrix address
Software Display of the software version
version
Hardware Display of the hardware version
version
Certificates Display of device approvals
Device
Display of the information relating to the HART
Manufacturer Manufacturer's identification character: Endress+Hauser (=17)
Device type Device type identification: TMT162
Date Individual use of this parameter
Hardware Revisions of the device's electronic components
revision
®
Available in ReadWin 2000, HART
Commuwin II with Matrix address
Security Set-up release code.
locking Input:
• Lock = 0
• Release (unlock) = 261
Reset to Reset to factory default values.
default Input: 162
0
Output Activate simulation mode.
simulation Input:
• OFF
• ON
Simulation Input of the simulation value (current).
value Input: 3.58 to 23 mA as of SW version 01.03.00.
To SW version 01.03.00 21.7 mA.
User For changing the 4 or 20 mA value by ± 0.150 mA
calibration
• Trimming 4 mA
(trim) analog
• Trimming 20 mA
output
®
Available in ReadWin 2000, HART
Commuwin II with Matrix address
PV PV value
82
Function group IDENTIFICATION
® handheld module DXR275/375,
®
device identification
Function group SERVICE FUNCTIONS
®
handheld module DXR 275/375,
Function group MEASURED VALUES
®
handheld module DXR275/375,
ReadWin ® DXR275/375,
2000 FieldCare
+ +
+ +
- +
- +
- +
- +
- +
®
ReadWin 2000 DXR275/375,
FieldCare
+ +
+ +
+ +
+ +
 SW 01.03.00  SW 01.03.00
®
ReadWin DXR275/375,
2000 FieldCare
+ +
Endress+Hauser
TMT162
CW II-
Matrix
VAH6
VAH7
-
-
-
-
CW II-
Matrix
V9H6
V9H5
V9H7
V9H8
-
CW II-
Matrix
V0H0