Endress+Hauser iTEMP HART TMT162 Bedienungsanleitung Seite 80

Commissioning
Available in ReadWin ® 2000, HART
Matrix address
Corrosion Sensor connection cable corrosion can lead to false measured value readings.
detection Therefore our unit offers the possibility to recognize any corrosion before the
measured values are affected. (see chapter 9.2.1).
There are 2 different steps selectable dependent on the application
requirements:
• off (warning output just before reaching the alarm set point. This allows
for preventative maintenance/trouble-shooting to be done.)
• on (no warning, immediate alarm)
Alarm for Input:
undershootin
• Off
g/
If the measuring range is undershot or overshot, the output signal is
overshooting
temperature-linear up to 3.8 mA or 20.5 mA and remains at these values
(as per NAMUR NE43).
• On
An error is signalled if the measured temperature corresponds to an output
value < 3.8 mA or > 20.5 mA, (see ' F ault condition' ) .
Mains filter Selection of mains filter
• 50 Hz
• 60 Hz (For North American region 60 Hz is default)
®
Available in ReadWin 2000, HART
Commuwin II with Matrix address
Display Activating the values to be shown on the device display:
• Display: PV
• Display: Sensor 1 value
• Display: Sensor 2 value
• Display: RJ value
• Display Analog output value
• Display: Status
• Display: Time
• Display: percentage value (on/off)
Primary value (PV) is displayed as a
percentage.
In order to activate the values to be shown in the device display using
Commuwin II and HART
of the values to be displayed and enter the sum.
• Display: time (2s, 4s, 6s, 8s)
• Display: figures after decimal point (0,1,2)
• Display PV text (customer specific text, 8 characters)
80
Function group SAFETY SETTINGS
® handheld module DXR275/375, Commuwin II with
Function group DISPLAY
®
handheld module DXR275/375,
®
handheld module DXR275/375: Add (DXR,CW=x)
ReadWin
+
 SW 01.03.00
+
ReadWin
(DXR,CW=1) +
(DXR,CW=2) +
(DXR,CW=4) +
(DXR,CW=8) +
(DXR,CW=16) +
(DXR,CW=32) +
2s (DXR,CW=0) < SW 01.03.00
4s (DXR,CW=64)
6s (DXR,CW=128)
8s (DXR,CW=192)
 SW 01.03.00
off (DXR,CW=0)
on (DXR,CW=64)
 SW 01.03.00
 SW 01.03.00
+
TMT162
® 2000 DXR275/375, CW II-
FieldCare Matrix
+ V2H4
 SW 01.03.00
-
+ V2H3
®
2000 DXR275/375,
FieldCare
+
+
+
+
+
+
< SW 01.03.00
 SW 01.03.00
 SW 01.03.00
 SW 01.03.00
+
Endress+Hauser
CW II-
Matrix
V6H0
V6H0
V6H0
V6H0
V6H0
V6H0
< SW
01.03.0
0
-
-
-
V6H1