Before Machine Start-Up; Checklist; Starting And Stopping The Machine - Nilfisk SW5500 Bedienungshandbuch

BEFORE MACHINE START-UP

Checklist

1. Have a full knowledge of the machine operating controls and their functions.
2. Insert the key (51) and start the machine (see the procedure in the following paragraph).
3. In the first 2 seconds after turning on, the multifunction display (71) shows the machine working hours (71-A), the type of
batteries set (71-B) and the current maximum machine speed setting (71-C).
4. Check the fuel reserve icon (71-P); if it is lit, range will be limited. Refuel with diesel or replace the LPG tank (see previous
paragraph).
5. Check the horn with switch (65), the reverse gear buzzer with switch (64) and the working light switch (67, optional) for proper
operation.
6. Check the parking brake (7 and 6). The brake must hold its (locked parked) setting firmly without easily being released (report
all defects immediately to Nilfisk Service Center).
7. Check the service brake pedal (6) for proper operation.
WARNING!
If the pedal is "spongy" or fades under pressure without an efficient braking force, do not drive the machine
(report all defects immediately to Nilfisk Service Center).
8. Make sure that there are no open doors/hoods and that the machine is in normal operating conditions.
Cleaning planning
1. Arrange long runs with a minimum of stopping or starting.
2. Allow a small amount of broom path overlap to ensure complete coverage.
3. Avoid making sharp turns, bumping or scraping the side of the machine.
Filling the DustGuard™ system water tank (optional)
1. Remove the plug (25) to reach the filler neck.
2. Fill the tank (24) with clean water. Do not fill the tank completely, leave a few centimetres from the edge.

STARTING AND STOPPING THE MACHINE

Starting the machine
1. Sit on the driver's seat (3) and adjust it with the lever (4) to allow easy reach of all controls.
NOTE
The driver's seat (3) is equipped with a safety sensor, which allows the machine to be driven only when the operator is
on the driver's seat.
2. Turn the ignition key (51) clockwise to the "I" position.
3. Wait for the multifunction display to show the work screen (71-D).
4. Turn the ignition key (51) to the start position "II", then release it when the engine starts.
5. After starting, let the engine idle for a few seconds.
CAUTION!
When starting do not press the accelerator pedal (5).
6. Disengage the parking brake.
7. Drive the machine to the working area, manoeuvring it by turning the steering wheel with your hands (1) and pressing the
accelerator pedal (5).
The speed can be adjusted by applying more or less pressure to the accelerator pedal (5).
The maximum running speed can be set with push-buttons (58) and (59).
8. The forward/reverse direction is selected with the relevant push-button (64) on the dashboard. Activation of reverse gear is
indicated by the buzzer and on the display (71-H).
WARNING!
When steering, avoid abrupt direction changes, pay careful attention and drive the machine at slow speed,
especially when the hopper is full or when operating on inclines.
Drive the machine slowly on inclines. Use the brake pedal (6) to control machine speed while descending
inclines.
Do not turn the machine on an incline; drive straight up or down.
NOTE
The machine has an anti-skid safety system, which where necessary reduces speed when steering and when the
machine is driving on a camber, regardless of the pressure applied to the pedal.
This reduction in speed is therefore not a malfunction but a characteristic which increases the stability and safety of the
machine in all conditions.
03/2016
All manuals and user guides at all-guides.com
1466472000 - SW5500, FLOORTEC R 985
INSTRUCTIONS FOR USE ENGLISH
19