Engine Oil Level Check And Oil Replacement (Lpg Version) - Nilfisk SW5500 Bedienungshandbuch

ENGINE OIL LEVEL CHECK AND OIL REPLACEMENT (LPG version)

Engine oil level check
CAUTION!
Running the engine with a low oil level can
damage the engine itself.
NOTE
(LPG version). The oil alert system will automatically
stop the engine before the oil level goes down under
the safety limit. To avoid a sudden engine stop,
always check the oil level before each start-up.
1. Drive the machine on a level ground and engage the
parking brake.
2. Turn the ignition key (51) to "0".
3. Open the engine compartment hood (19) and fasten it with
the support rod (47).
4. Lift and remove the right side panel (31).
5. Remove the cap (A, Fig. 25).
6. Check the oil level. If it is below the upper limit (E), top up
with the recommended oil until you reach the upper limit.
7. Reinstall the filler cap (A) safely.
Engine oil change
CAUTION!
The discharged engine oil must be disposed of
properly according to the Law in force.
NOTE
It is advisable to change the oil when the engine is
still hot, to make the oil downflow easier.
8. Perform steps 1 to 4 of the previous procedure.
9. Remove the cap (A, Fig. 25).
10. Unhook the drain hose (B) and bring it towards the outside
of the machine.
11. Remove the drain plug (C) from the hose and drain the oil
into a suitable container, then refit the oil drain plug and
return the hose to its initial location.
12. Remove the filler cap (D) and pour in the new oil through
the filler until it reaches the upper limit (E) of the cavity.
NOTE
As for engine oil type and quantity, see the Technical
Data chapter and the Engine Manual.
13. Reinstall the filler cap (D) and the cap (A) safely.
03/2016
All manuals and user guides at all-guides.com
1466472000 - SW5500, FLOORTEC R 985
INSTRUCTIONS FOR USE
LPG VERSION
E
Figure 25
ENGLISH
E
C
A
B
D
P100926
35