Use; Before Machine Start-Up - Nilfisk CA 451 Betriebsanleitung

ENGLISH

USE

WARNING!
On some points of the machine there are some adhesive plates indicating:
– DANGER
– WARNING
– CAUTION
– CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if damaged.

BEFORE MACHINE START-UP

Brush/pad-holder installation/removal
1. Disconnect the power supply cable (3) from the electrical mains.
2. Place the brush (A, Fig. 1) or the pad-holder (B) under the deck (14).
3. Lower the deck on the brush/pad-holder by pressing the pedal (8).
4. Connect the power supply cable (3) to the electrical mains.
5. Engage the brush or pad-holder by pressing the switch (51) for a few seconds.
WARNING!
Do not press the switch (51) too much, otherwise the machine will start.
6. To remove the brush/pad-holder lift the deck by pressing the pedal (8), then manually remove the brush/pad-holder from the
hub, by turning it in the opposite direction to the normal rotation direction.
Available brushes and their relevant application guides (suggestions only)
Models
General cleaning:
Concrete
Terrazzo fl oor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles
Polishing:
Rubber tiles
Marble
Vinyl tiles
10
USER MANUAL
MIDLITE GRIT 180
909 6750 000(4)2010-03 A
Figure 1
MIDGRIT 240 PROLENE
CA 451 - CA 531
S311343
PROLITE UNION MIX