Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
Hybrid motor (optional)
1.
Perform steps 1 to 3 of the machine start-up paragraph.
2.
Ignition of the engine is not necessary while the batteries retain a sufficient level of charge.
3.
Check the battery charge while working. While at least one segment of the battery icon
(A, Fig. 1) is lit and not flashing on the multifunction display (71), the machine can be used
with the engine off. When the battery icon (A) has only one flashing segment remaining
it is advisable to start the engine, or else to recharge the batteries using the on-board battery
charger (see procedure in the Maintenance chapter).
4.
To start using the machine again with the engine off, press the push-button (36) and hold it
down until the engine turns off.
5.
When the multifunction display shows screen (B), a complete battery charging cycle must be
performed using the on-board battery charger. Complete the job in progress before taking the
machine to the area for charging its batteries.
6.
Perform a complete charging cycle before using the machine again (see procedure in the
Maintenance chapter).
Stopping the machine
1.
To stop the machine, release the accelerator pedal (5).
2.
To stop the machine quickly, also press the service brake pedal (6).
WARNING!
The machine regulates its speed in proportion to the pressure on the accelerator pedal, accelerating and
decelerating as a result. In some particular working and environmental conditions (e.g. steep descents), the
automatic deceleration may deactivate itself to protect the system. For this reason, always use the service brake
(6) to be sure of the machine's stopping distance.
3.
In case of emergency, press the emergency push-button (69) to immediately stop the machine.
To deactivate the emergency push-button (69), turn it clockwise.
WARNING!
The emergency push-button (69) also deactivates the machine's automatic deceleration system; if operated
while moving, use the service brake (6) to stop the machine.
4.
Turn the ignition key (51) to "0" and remove it.
PARKING BRAKE
1.
Engage the parking brake by pressing the pedal (6) and engaging the lever (7).
2.
Disengage the parking brake by pressing and releasing the pedal (6).
WARNING!
Before performing any maintenance, repair, cleaning or replacement procedure engage the parking brake.
Engage the parking brake when parking the machine on a slope.
WARNING!
Before leaving the machine unattained, be sure that the parking brake can stop the machine with a large safety
margin.
WARNING!
When using the machine on slopes, respect the maximum gradient values marked on the machine itself (see
technical characteristics table).
20
All manuals and user guides at all-guides.com
INSTRUCTIONS FOR USE
SW5500, FLOORTEC R 985 - 1466472000
,
CHARGE
OK
E
A
B
P100924
Figure 1
C
D
03/2016
Werbung
Inhaltsverzeichnis
Fehlerbehebung
