Skirt Height And Operation Check; Preliminary Operations - Nilfisk SW5500 Bedienungshandbuch

ENGLISH

SKIRT HEIGHT AND OPERATION CHECK

Preliminary Operations

1. Empty the hopper (as shown in Use chapter), because the
weight of the waste inside the hopper can affect the skirt
height check.
2. Drive the machine on a level ground that is suitable for
checking the skirt height.
3. Turn the ignition key (51) to "0" and engage the parking
brake.
Side Skirt Check
4. Remove the left and right doors (14 and 13) by turning the
fasteners.
NOTE
The right door fasteners (13) must be turned with a
tool.
5. Check the condition of the side skirts (A, Fig. 18) and (B).
Replace the skirts when they have cuts (C, Fig. 19) larger
than 20 mm or cracks/tears (D) larger than 10 mm (for skirt
replacement, refer to the Service Manual).
6. Check that the distance from the floor of the side skirts (A,
Fig. 18) and (B) is within 0 - 3 mm (E, Fig. 20).
If necessary, loosen the nuts (F, Fig. 18) and adjust the
skirt position. Finally, tighten the nuts (F).
Front and Rear Skirt Check
7. Remove the main broom as shown in the relevant
paragraph.
8. Check the condition of the front (G, Fig. 21) and rear skirts
(H) and (I).
Replace the skirts when they have cuts (C, Fig. 19) larger
than 20 mm or cracks/tears (D) larger than 10 mm.
9. Check that the front (G, Fig. 21) and rear skirt (I) slightly
rub ground without being detached from it (J, Fig. 20).
10. For the skirt replacement, see the Service Manual.
Reassembly
11. Assemble the components in the reverse order of
disassembly.
32
All manuals and user guides at all-guides.com
INSTRUCTIONS FOR USE
SW5500, FLOORTEC R 985 - 1466472000
F B
Figure 18
> 10 mm
(> 0,4 in)
D
Figure 19
E
0÷3 mm
(0÷0,12 in)
Figure 20
G
Figure 21
A F
F
P100912
C
> 20 mm
(> 0,8 in)
P100913
J
FRONT
P100914
H I
P100915
03/2016