Engine Oil Level Check And Oil Replacement (Diesel Version); Engine Oil Change - Nilfisk SW5500 Bedienungshandbuch

ENGLISH

ENGINE OIL LEVEL CHECK AND OIL REPLACEMENT (DIESEL version)

Engine oil level check
CAUTION!
Running the engine with a low oil level can
damage the engine itself.
1. Drive the machine on a level ground and engage the
parking brake.
2. Turn the ignition key (51) to "0".
3. Open the engine compartment hood (19) and fasten it with
the support rod (47).
4. Lift and remove the left side panel (32).
5. Remove the cap (A, Fig. 24).
6. Check the oil level. If it is below the upper limit (B), top up
with the recommended oil until you reach the upper limit.
7. Reinstall the filler cap (A) safely.

Engine oil change

CAUTION!
The discharged engine oil must be disposed of
properly according to the Law in force.
NOTE
It is advisable to change the oil when the engine is
still hot, to make the oil downflow easier.
8. Perform steps 1 to 4 of the previous procedure.
9. Remove the cap (A).
10. Unhook the drain hose (C) and bring it towards the outside
of the machine.
11. Remove the oil drain plug (D) from the hose and drain the
oil into a suitable container, then refit the oil drain plug and
return the hose to its initial location.
12. Pour the new oil through the filler (E) until it reaches the
upper limit (B).
NOTE
As for engine oil type and quantity, see the Technical
Data chapter and the Engine Manual.
13. Reinstall the filler cap (A) safely.
34
All manuals and user guides at all-guides.com
INSTRUCTIONS FOR USE
SW5500, FLOORTEC R 985 - 1466472000
DIESEL VERSION
A
C
Figure 24
LPG VERSION
E
D
B
P100925
F
03/2016