Spark Plug - probst EASYFILL EF-H Betriebsanleitung

Cleaning
1.Remove the air cleaner cover and foam filter element, as
described in the inspection procedure.
2.Remove the paper element from the air cleaner base.
3.Paper element:
Tap the element several times on a hard surface to remove
excess dirt, or blow compressed air [not exceeding 207 kPa (30
psi)] through the filter from the wire screen side. Never try to
brush off dirt; brushing will force dirt into the fibers. Replace the
paper element if it is excessively dirty.
4.Foam element
Clean in warm, soapy water or nonflammable solvent, rinse and
dry thoroughly. Do not use gasoline as a cleaning solvent,
because that would create a risk of fire or explosion.
For GXV160K1 only:
Dip the element in clean engine oil, then squeeze out all excess oil.
NOTE
Excess oil will restrict air flow through the foam filter and may
transfer to the paper filter, soaking and clogging it. (GXV160K1)
5.Wipe dirt from the air cleaner base and cover using a moist rag.
Be careful to prevent dirt from entering the air duct that leads to
the carburetor.
6.Reinstall the air cleaner elements, and make sure both elements
are correctly positioned. Install the air cleaner cover and tighten
the wing bolt securely (1for GXV140, 2 for GXV160K1).
21

Spark Plug

Recommended Spark Plugs:
NGK: BPR5ES - NIPPONDENSO Co., Ltd.: W16EPR-U
The recommended spark plug is the correct heat range for normal
engine operating temperatures. The engine can be damaged if a
spark plug with an incorrect heat range is used.
For good performance, the spark plug must be correctly gapped
and free of deposits.
1.Disconnect the cap (1) from the
spark plug (2), and remove any
dirt from the spark plug area.
2.Use the correct size plug
wrench (3) to remove the spark
plug.
3.Inspect the spark plug.
Replace it if damaged, badly
fouled, if the sealing washer is in
p o o r c o n d i t i o n , o r i f t h e
electrode is worn. If the spark
plug is to be reused, clean it with
a wire brush.
4.Measure the electrode gap with
a suitable gauge. The correct
g a p i s 0 . 7 - 0 . 8
(0.028 - 0.031 in). If adjustment
is needed, correct the gap by
carefully bending the side
electrode.
(1)
(3)
(2)
0,7 ~ 0,8 mm
m m
22