Imow - Machine Settings; Setting The Rain Sensor - Viking MI 422 Gebrauchsanleitung

– Start time:
Start of the next planned mowing
operation
– Total number of completed mowing
operations
– Mowing hours:
Duration of all completed mowing
operations in hours
– Distance:
Total distance covered in metres
– Ser.-No.:
Serial number of the robotic mower.
This can also be found on the
identification plate (see Machine
overview). ( 3.1)
– Battery:
Serial number of the battery
– Software:
Installed machine software
4. Lawn status:
Information on the lawn
– Mowing area in square metres:
This value is entered during initial
installation or new installation (
– Round time:
Duration of one circuit around the
mowing area in minutes and seconds
– Starting points 1 – 4:
Distance of the relevant starting point
from the docking station in meters,
measured in a clockwise direction
( 10.15)
– Circumference:
Circumference of the mowing area in
metres
– Edge mowing:
Frequency of edge mowing per week
( 10.14)
0478 131 9923 B - EN
10.10 Settings
1. iMow:
Adapt machine settings
( 10.11)
2. Installation:
Adapt and test the installation
( 10.14)
3. Safety:
Adapt the safety settings (
4. Service:
Maintenance and service (
5. Dealer area:
9.3)
This menu is protected by the
dealer code. Your VIKING
specialist dealer performs a variety of
maintenance and service operations with
the aid of this menu.
10.11 iMow – machine settings
1. Rain sensor:
The rain sensor can be set so that
mowing is interrupted or does not
start when it is raining.
● Setting the rain sensor (
2. Mowing time:
Set the standard for the duration of a
mowing operation after activation of
the command "Start mowing". (
3. Delay:
Set the standard for the delay
following activation of the command
"Start time-delayed mowing". (
4. Status screen:
Select the information that is to
appear in the status screen.
( 10.13)
● Setting the status screen (
5. Time:
Set the current time.
The set time must correspond to the
actual time in order to prevent inadvertent
mowing by the robotic mower.
6. Date:
Set the current date.
10.16)
The set date must correspond to the
actual calendar date in order to prevent
inadvertent operation of the robotic
10.17)
mower.
7. Date format:
Set the required date format.
8. Track offset:
The robotic mower travels along the
perimeter wire at a 6 cm offset from
the wire as standard. With this offset,
optimum docking is ensured. The iRuler is
also designed for a track offset of 6 cm.
VIKING recommends that the
standard setting of 6 cm not be
changed.
● Only if necessary, open the selection
10.12) window with OK and set the required
value (3 cm to 9 cm).
10.5)
10.5)
10.13)
113