Checking Installation; Programming The Robotic Mower - Viking MI 422 Gebrauchsanleitung

9.8 Checking installation

Start the test run by pressing the OK
button – this does not activate the
mowing blade.
Close the flap of the robotic
mower. ( 14.2) Only once the flap has
been closed does the robotic mower start
automatically and follow the edge along
the perimeter wire.
0478 131 9923 B - EN
As the robotic mower follows the edge,
walk behind it and ensure:
– that the robotic mower follows the edge
of the mowing area as planned,
– that the clearances to obstacles and the
borders of the mowing area are correct,
– that docking in and out takes place
correctly.
The distance covered is shown on the
display – this metric specification is
required for setting starting points at the
edge of the mowing area. (
● Read off the displayed value at the
required location and write it down.
Manually set starting points after initial
installation.
The following of edges is automatically
interrupted by obstacles, during operation
on excessively steep slopes or by pressing
the STOP button.
● If the test run has been interrupted
automatically, correct the position of the
perimeter wire and remove any
obstacles.
● Check the position of the robotic mower
before continuing edge following. The
machine must either be located on the
perimeter wire or within the mowing
area with the front facing the perimeter
wire.
Continuation following interruption:
After an interruption, continue edge
following with OK.
It is recommended by VIKING not
to interrupt the test run. Possible
problems when following the edge
of the mowing area or when
docking may not be recognised.
The test run can be repeated
following initial installation if
necessary. (
Completion of the test run:
The next step of the installation assistant is
called up when the robotic mower docks
following a complete circuit.
10.15)

9.9 Programming the robotic mower

Enter the size of the lawn and
confirm with OK.
10.14)
105