Routing The Perimeter Wire - Viking MI 422 Gebrauchsanleitung

● After completing this installation
work, press the OK button on the
display.
If an external docking station has
been installed, VIKING
recommends defining at least one
starting point outside the corridor to
the docking station after initial
installation is complete. The starting
frequency should be defined so that
0 of 10 mowing operations (0/10)
are started at the docking station
(starting point 0). ( 10.15)
0478 131 9923 B - EN
Lift the robotic mower slightly by the
carrying handle (1) to relieve the weight on
the drive wheels. Push the machine,
resting on its front wheels, into the docking
station.
Then press the OK button on the
display.
If the battery is discharged, a
plug symbol appears instead
of the battery symbol at the
top right corner of the display after
docking and the battery is charged
while the perimeter wire is being
routed. ( 14.7)

9.5 Routing the perimeter wire

Please read and observe the entire
"Perimeter wire" section before
performing wire routing. (
In particular, plan the routing,
observe the wire clearances and
install no-go areas, reserve wire,
linking sections, secondary
areas and corridors during wire
routing.
Fasten the perimeter wire (1) to the ground
on the left A or right B as appropriate,
next to the floor plate, directly next to a
wire outlet, using a fixing pin (2).
11.)
Provide a free wire end (1) with a length of
approx. 1 m.
99