Mounting Instructions; Tools Required For Assembly - Carromco TOLEDO-301 Bedienungsanleitung

Center of the
Dartboard (Bull's Eye)
Throwing line
237cm

TOOLS REQUIRED FOR ASSEMBLY:

Screwdriver and drill - (not included)
3 AA Batteries or Adapter (not included)
1. The battery compartment is accessed from the rear of the dartboard by
removing the screw from the base and lifting the back cover. Install 3 AA
batteries (not included) to the battery holder. Replace the back cover
and fix with screw. Or Insert an adapter into an electric outlet then insert
the Plug into the jack on the right side of the dartboard. The adapter
shall be with 230V AC/ 1000mA DC.
2. Preparing the darts: Screw the point (tip) and shaft into the grip (barrel).
If extra flights, bend the flight into shape and put it into the shaft.
3. Suspend the dartboard by means of the two mounting holes in the back.
2 screws are provided for mounting on the wall. Should the screws not
be suitable for your wall, change them for suitable screws. According to
international dart match rules, the dartboard should be suspended in
such a way that the height from the floor to the center of the dart circle is
1.73 m (68") and the distance from the throwing line to the board is 2.37
(7 feet 91/4 inches).
Place two marks side-by-side of the selected wall studs 192cm (75 5/8")
4.
above the floor, with 14cm (5 1/2") between them. Screw two screws
into the reference marks until the screw heads are protruding about
13mm (1/2") from the wall.
5. Line up the mounting holes on the back of the game with the screw
heads, then mount the game. It may be necessary to adjust the screws
until the board fits snugly against the wall.
6. Familiarize yourself with the function of your dartboard before use.
Should you suspect the dartboard does not work correctly, please refer
to the TROUBLE SHOOTING section in this manual first.

MOUNTING INSTRUCTIONS

Wall
2