Saving/Changing Aux Code And Aux Transponder - Sygonix Touch S Bedienungsanleitung

r) Saving/changing AUX code and AUX transponder
The respective AUX code must be programmed for the AUX function
section 8. p). A special AUX transponder can also be paired, which can serve for switching the
AUX output.
Important!
All codes (master code, user codes, standard access code, bypass code, AUX code)
must have the same length. For example, if a master code consists of 5 digits, the
AUX code must also have 5 digits.
A new transponder must be used at all times, which has not yet been saved as a user
transponder.
Only one transponder can be paired as an AUX transponder. When pairing a new
transponder as an AUX transponder, the code lock automatically deletes the existing
AUX transponder.
Proceed as follows:
• Enter the master code twice to start the programming mode, as described in section 8. a).
The yellow LED must light up.
• Enter the programming code for the AUX code:
• The code lock will emit 2 beeps.
• Enter the AUX code. It overwrites the existing AUX code, if any.
Example:
• The code lock will emit 2 beeps.
• An AUX transponder can be paired by holding the transponder in front of the RFID sensor.
Once the transponder is recognised, the code lock emits a long beep and the transponder is
saved as an AUX transponder.
• Other settings can now be made, if desired. Press the
mode.
For example, to set the AUX code to "9999", you should use a 4-digit master code. If you want to
use a longer master code, the AUX code must have the matching number of digits:
selected according to
button to exit the programming
69