Changing Standard Access Code - Sygonix Touch S Bedienungsanleitung

d) Changing standard access code
When the access mode has been set to "0" as described in section 8. c), the changeover contact
can be activated either via a valid transponder or via the standard access code.
Thus you can still open the door even if you have forgotten or lost your transponder. The same
standard access code applies to all users.
When the access mode has been set to "1" or "2" as described in section 8. c), the
standard access code is disabled for security reasons. The code alone is then not
enough to open the door!
Important!
All codes (master code, user codes, standard access code, bypass code, AUX code)
must have the same length. For example, if a master code consists of 5 digits, the
standard access code must also have 5 digits.
By default, the standard access code is "3333". The number of digits in the standard
access code (5 to 8 digits) depends on the number of digits in the master code (for
example, if the master code has five digits, the standard access code is "33333").
Proceed as follows:
• Enter the master code twice to start the programming mode, as described in section 8. a).
The yellow LED must light up.
• Enter the programming code for the standard access code:
• The code lock will emit 2 beeps.
• Enter the new standard access code. It automatically overwrites the existing code.
Example:
• The code lock will emit a long beep.
• Other settings can now be made, if desired. Press the
mode.
For example, to set the standard access code to "6666", you should use a 4-digit master code.
If you want to use a longer master code, the standard access code must have the matching
number of digits:
54
button to exit the programming