Selecting The Access Mode - Sygonix Touch S Bedienungsanleitung

c) Selecting the access mode
The changeover contact can be activated in three different ways. The access mode can be
changed for this purpose.
Proceed as follows:
• Enter the master code twice to start the programming mode, as described in section 8. a).
The yellow LED must light up.
• Enter the programming code for the access mode:
• The code lock will emit 2 beeps.
• Select the desired access mode:
= transponder or standard access code (the same applies for all users; see programming
in section 8. d)
= only transponder
= transponder and respective user code; a separate user code must be saved for each
user
• The code lock will emit a long beep.
• Other settings can now be made, if desired. Press the
mode.
Example for changeover contact activation only via transponder (first start programming mode,
see section 8. a):
button to exit the programming
53