Product Label; Function; Power Supply; Remote Control - Truma GO2 RH3 Gebrauchsanweisung

GO2 RH3
4.2

Product label

The appliance type and serial number are printed on the
type plate�
Type plate
To ensure that the general operating permit (ABE) is va-
lid, the type plates must be present on the left and right
of each of the mounting tubes�
Fig. 4
The type plate of the remote control can be found in the
remote control's battery compartment�
The type plate of the control unit is located on the un-
derside of the control unit�
4.3

Function

Coping with inclines (max. climbing ability)
The GO2 RH3 has been designed to cope with inclines
of up to 13 % bearing a gross weight of 1800 kg or
25 % bearing a gross weight of 1200 kg on a suitable
surface�
 13 % = 13 metre difference in altitude over a dis-
tance of 100 metres
Once the drive rollers have been engaged completely
against the tyres using the engagement lever provided,
the manoeuvring system is ready for operation�
Manoeuvring is carried out exclusively via the remote
control, which transmits radio signals to the control
unit� A separately installed 12 V lead-acid battery or sui-
table lead-gel battery (not supplied) provides the control
unit with electrical power�
4.4

Power supply

Always observe the operating instructions and the
"Safety instructions" prior to starting� The vehic-
le user is responsible for correct operation of the
device�
4.4.1 Power supply
For optimum operation, we recommend the Truma Po-
werSet BC and high-performance Optima® batteries�
60040-00325 ∙ 00 ∙ 08/2022
1 2
Body-mounted batteries (caravans with self-sufficient
power supply with correspondingly large capacity; see
table below) are also suitable�
Batteries
NOTICE
Malfunctions during operation due to incor-
rect power source
To guarantee proper operation of the mano-
euvring system, it may only be operated with a
charged battery (≥ 12 V)�
Operation with a charger as power source is
not possible and prohibited�
Recommended battery capacities
The 12 V battery used must be certified in accordance
with the national standards and regulations of the coun-
try of use and in accordance with the manufacturer's in-
stallation instructions� The battery must be dimensioned
in accordance with the technical requirements of the
manoeuvring system�
Starter batteries are not suitable�
Batteries with greater capacity allow the manoeuvring
system to be used for longer�
Round cell
technology
Mano- Capacity in Ah
euvring
system
GO2 55
RH3
Charger
For optimum battery charging, we recommend the Tru-
ma BC 10 charger (a component of the PowerSet BC),
which is suitable for all battery types up to 200 Ah�
Fig. 5
4.5

Remote control

4.5.1 The remote control's functions
NOTICE
Damage to the remote control due to mois-
ture or heat
If moisture gets into the remote control or it is
exposed to strong sunlight for too long, this can
damage the remote control�
Protect the remote control from moisture�
Protect the remote control from strong
sunlight�
If there are other devices that work on the same fre-
quency (e�g� wireless garage doors, video surveillance
Product description
Gel / Lead-acid battery
AGM (liquid electrolyte)
70 80
EN 27