Change Grinding Disc - Parkside PSBS 240 C2 Originalbetriebsanleitung

6. Check the tape run by manually turn-
ing the grinding belt.
When assembling the grinding belt,
pay attention to the direction of tra-
vel.

Change grinding disc

Information on replace-
ment:
• Never operate the device without
protective equipment.
• Ensure that the rotation speed
stated on the grinding disc (
19) is the same or higher than the
nominal rotation speed of the de-
vice.
• Ensure that the grinding disc
dimensions match those of the
device.
• Only use fl awless grinding discs.
Perform a ringing test. When
striking the grinding disk with a
plastic hammer, this should result
in a clear sound.
• Never re-drill a locating hole
which is too small to make it
larger.
• Never use separate bushings or
adapters in order to make grind-
ing discs whose hole is too large
fi t the device.
• Do not use any saw blades.
• To clamp the grinding tools only
use the clamping fl ange provid-
ed. The pads between the clamp-
ing fl ange and the grinding tools
must be made of elastic materials
e.g., rubber, soft cardboard etc.
• Always reassemble the device
completely after replacing the
grinding disc.
Switch the device off and remove
the mains plug.
Allow the device to cool down.
Wear protective gloves when
changing the grinding discs in or-
der to avoid cutting damages.
1. Remove the spark
protection ( 1) (see „Assem-
ble/set spark protection).
2. Loosen the 3 fi xing screws (15)
and remove the grinding disc
cover (16).
3. Loosen the fi xing screws
( 11) and remove the grinding
belt cover ( 12) (see „Chang-
ing the grinding belt").
4. Unscrew the grinding disc nut
(19a) in the clockwise direction,
by holding the nut of the opposite
roller of the grinding belt in place
(see small image). Hold it tight
with a 19mm socket wrench or
pliers.
5. Remove the clamping fl ange
(19b) and the grinding disc (19).
6. Set up the new grinding disc (19)
and the clamping fl ange and man-
ually screw the grinding disc nut
(19a) in the anti-clockwise direction.
7. Screw the grinding disc cover (16).
8. Re-fasten the sanding belt
cover ( 12) using the mounting
screws ( 11).
9. Set the spark protection (
and the workpiece support (
18) so that the distance between
the grinding disc (19) is max.
2 mm (see „Assembly").
The grinding disc nut must not be
screwed too tightly in order to avoid a
breaking of the grinding disc and nut.
GB IE
1)
29