Change Grinding Disc; Change Dry Grinding Disc - Parkside PNTS 250 C2 Originalbetriebsanleitung

GB NI
IE
submerged in water up to the water
level mark
( 13).
• Stand in front of the wet grinding disc
( 1).
• Hold the workpiece with both hands
and lower it slowly onto the wet grind-
ing disc.
• The workpiece can also be supported
on the teeth of the water tank (

Change grinding disc

Information
on replacement:
- Never operate the device without
protective equipment.
- Ensure that the rotation speed stated
on the grinding disc is the same or
higher than the nominal rotation
speed of the device.
- Ensure that the grinding disc dimen-
sions match those of the device.
- Only use flawless grinding discs
(sound test: an undamaged grinding
disc hanging freely on a string will
result in a clear sound if it is tapped
with a plastic hammer).
- Never re-drill a locating hole which is
too small to make it larger.
- Never use separate bushings or
adapters in order to make grinding
discs whose hole is too large fit the
device.
- Do not use any saw blades.
- To clamp the grinding tools only use
the clamping flange provided. The
pads between the clamping flange
and the grinding tools must be made
of elastic materials e.g., rubber, soft
cardboard etc.
- Always reassemble the device com-
pletely after replacing the grinding
disc.
14
on the water tank
Switch the device off and remove
the mains plug.
Allow the device to cool down.
Wear protective gloves when
changing the grinding discs in or-
der to avoid cutting damages.

Change dry grinding disc:

13).
1. Remove the spark protection (
2. Loosen the fixing screws and re-
3. Unscrew the grinding disc
4. Remove the clamping flange (23)
5. Fit on the new dry grinding disc
6. Tighten the grinding disc nut
7. Screw the dry grinding disc
8. Adjust the spark protection hold-
2) (see „Assemble/adjust
spark protection").
move the dry grinding disc cover
( 4) from the protective hood
(25).
nut (22) with a screw wrench
(AF 19 mm) and hold against
the grinding disc with one hand
wearing a glove.
Unscrew the nut (right-hand
thread): turn counter-clockwise.
and the dry grinding disc (5).
(5) with the intermediate card-
board layers (24) and the clamp-
ing flange (23), and screw the
grinding disc nut (22) manually
onto the nut (right-hand thread):
turn clockwise.
with a screw wrench (AF 19 mm)
applying modest manual force.
cover (4).
er ( 18) and the workpiece
6) - The distance
support (
from the dry grinding wheel (5)
must not exceed 2 mm (see „As-
sembly").