Grinding With The Grinding Disc; Tape Loops; Change Grinding Belt; Change Grinding Disc - Parkside PSBS 240 C2 Originalbetriebsanleitung

GB IE NI
Grinding with the grinding
disc
Fold down the spark protec-
tor ( 1) when grinding in
order to avoid injury from
sparks.
The arrow on the protective hood
( 3) shows the direction of rota-
tion of the grinding disc.
• Place the workpiece on the workpiece
support ( 18) and slowly bring it to
its desired angle on the grinding disc
( 19).
• Move the workpiece slightly from side
to side in order to achieve an optimal
grinding result. This way, the grinding
disc is worn uniformly. Occasionally,
allow the workpiece to cool down.

Tape loops

The arrow on the protective hood
( 9) shows the direction of rota-
tion of the grinding belt.
• Firmly hold the workpiece, do not ex-
ert any strong force.
• Move the workpiece slightly from side
to side in order to avoid a one-sided
wear of the grinding belt.
• Always grind the pieces of wood in
the direction of the wood grain in or-
der to avoid chipping.

Change grinding belt

1. Loosen the 2 fixing screws (11)
and hang out the grinding belt
cover (12).
2. Press the clamping lever (7)
downwards and detract the
12
CY
grinding belt (10).
3. Place the new grinding belt (10)
in the centre on the upper (20a)
and lower (20b) rollers.
4. Push the clamping lever grinding
belt (7) and mount the grinding
belt cover (12).
Set the tape run:
5. The tape run accuracy is set by
turning the adjusting screw for
belt run (8).
6. Check the tape run by manually
turning the grinding belt.

Change grinding disc

Information on replace-
ment:
• Never operate the device without
protective equipment.
• Ensure that the rotation speed
stated on the grinding disc (
is the same or higher than the nomi-
nal rotation speed of the device.
• Ensure that the grinding disc dimen-
sions match those of the device.
• Only use flawless grinding discs
(ringing test: when you strike the
grinding disc with a plastic ham-
mer, it results in a clear sound).
• Never re-drill a locating hole
which is too small to make it
larger.
• Never use separate bushings or
adapters in order to make grind-
ing discs whose hole is too large
fit the device.
• Do not use any saw blades.
• To clamp the grinding tools only
use the clamping flange provided.
The pads between the clamping
flange and the grinding tools must
be made of elastic materials e.g.,
rubber, soft cardboard etc.
19)