Switching On And Off; Grinding With The Grinding Disc; Change Grinding Disc - Parkside PDOS 200 C2 Originalbetriebsanleitung

least as high as what has been
specified on the name plate of
the device.
- Do not use broken, cracked or
otherwise damaged grinding
discs.
- Never operate the device without
the visual protection disc.
- Always inspect the grinding disc
before starting the device:
Check the distance between the
spark protection and grinding
disc as well as workpiece support
and grinding disc (distance maxi-
mum 2 mm).
- The grinding disc must be re-
placed once the spark protec-
tion and workpiece support on
the grinding disc are no longer
spaced at 2 mm.
- Switch on the equipment only
when it is safely installed on the
work surface.
Keep your hands away from
the grinding disc when the
device is in operation. Injury
hazard!

Switching on and off

Ensure that the mains voltage
matches the specifications on the
rating plate.
Connect the equipment to the
mains.
1. To switch on, press the "I" On switch
and the device starts up (see
2. To switch off, press the "0" off switch and
the device switches off (see
After switching on the device, wait until the
device has reached its max. speed. Only
then must you start with the grinding.
Test run:
Before starting work and after each
change of grinding disc, carry out a test
run of at least 60 seconds with no load.
Switch off the equipment immediately if the
disc runs lumpy, substantial vibrations oc-
cur, or abnormal noises are generated.
Grinding with the grinding
disc
• Place the workpiece on the workpiece
support (
its desired angle on the grinding disc
(
• Move the workpiece slightly from side
to side in order to achieve an optimal
grinding result. This way, the grinding
disc is worn uniformly. Occasionally,
allow the workpiece to cool down.

Change grinding disc

14a).
14b).
The disc will continue to
run after the equipment is
switched off. There is a risk
of injury.
Fold down the spark protector (1)
when grinding in order to avoid
injury from sparks.
The arrow on the protective hood
(
5) shows the direction of rota-
tion of the grinding disc.
11) and slowly bring it to
10).
Information on replace-
ment:
• Never operate the device without
protective equipment.
GB MT
31