Workpiece Supports Assemble/Set; Screw Device On To Workbench; Operation - Parkside PSBS 240 C2 Originalbetriebsanleitung

2. Set the spark protection (1) with
the adjusting screw (2) so that the
distance between the grinding
disc (19) and the spark protection
is max. 2 mm (see small image).
Periodically readjust the spark pro-
tection in order to offset the wear
and tear of the grinding disc (dis-
tance max. 2 mm).
Workpiece supports
assemble/set
1. Screw the workpiece supports
(6/18) on to the device.
2 positions (see
possible for the tape loop.
2. To do so, use the screws (5a/17a),
washers (5b/17b), toothed lock
washer (5c/17c) and star grip
nuts (5/17) provided.
3. Set the workpiece support of the
grinding belt (19) with the star
grip nut (17) so that the distance
between the grinding disc (19)
and the workpiece support is
max. 2 mm (see small image).
Periodically readjust the workpiece
support in order to offset the wear
and tear of the grinding disc (dis-
tance max. 2 mm).
Screw device on to
workbench
Screw the device onto the work-
bench with 4 screws and nuts.
Insert the screws through the 4 bore
holes (13) on the base of the device.
The screws and nuts required for
assembly are not part of the scope
of delivery.

Operation

A + B) are
Caution! Risk of injury!
- Always disconnect the plug from
the mains socket before working.
- Use only grinding disks and acces-
sories recommended by the manu-
facturer. The use of other insertion
tools and other accessories may
cause risk of injury.
- Only use grinding tools which bear
information about the manufacturer,
type of binding, dimension and
permitted number of revolutions.
- Only use grinding discs where the
printed rotational speed is at least
as high as what has been specifi ed
on the name plate of the device.
- Do not use broken, cracked or other-
wise damaged grinding disks.
Change any damaged or heavily
worn grinding discs.
- Only use the device when both grin-
ding belt and the grinding disc are
assembled.
- Never operate the device without
the visual protection disk.
- Always use protective goggles even
if you are protected against sparks.
- Always inspect the grinding disc
before starting the device:
Check the distance between the
spark protection and grinding disc
as well as workpiece support and
grinding disc (distance maximum
2 mm).
- The grinding disc must be replaced
once the spark protection and
workpiece support on the grinding
disc do not have distance of max.
2 mm.
- Switch on the equipment only when
it is safely installed on the work sur-
face.
GB IE
27