Switching On And Off; Grinding With The Grinding Disc; Change Grinding Disc - Parkside PDOS 200 B2 Originalbetriebsanleitung

GB IE
- The grinding disc must be re-
placed once the spark protection
and workpiece support on the
grinding disc do not have dis-
tance of max. 2 mm.
- Switch on the equipment only
when it is safely installed on the
work surface.
Keep your hands away from
the grinding disc when the
device is in operation. Injury
hazard!

Switching on and off

Ensure that the mains voltage
matches the specifications on the
rating plate.
Connect the equipment to the mains.
1. To switch on, press the "I" On switch
and the device starts up (see
2. To switch off, press the "0" off switch
and the device switches off (see
14b).
After switching on the device, wait until the
device has reached its max. speed. Only
then must you start with the grinding.
The disc will continue to
run after the equipment is
switched off. There is a risk
of injury.
Test run:
Before starting work and after each
change of grinding disc, carry out a test
run of at least 60 seconds with no load.
Switch off the equipment immediately if the
disc runs lumpy, substantial vibrations oc-
cur, or abnormal noises are generated.
28
Grinding with the grinding
disc
The arrow on the protective hood
(
tion of the grinding disc.
• Place the workpiece on the workpiece
support (
its desired angle on the grinding disc
( 10).
• Move the workpiece slightly from side
to side in order to achieve an optimal
grinding result. This way, the grinding
disc is worn uniformly. Occasionally,
allow the workpiece to cool down.
• The magnifying glass set into the spark
protection window (
work accurately.

Change grinding disc

14a). • Never operate the device without
• Ensure that the rotation speed
• Ensure that the grinding disc
• Only use flawless grinding discs
• Never re-drill a locating hole
• Never use separate bushings or
5) shows the direction of rota-
11) and slowly bring it to
Information on replacement:
protective equipment.
stated on the grinding disc (
10) is the same or higher than the
nominal rotation speed of the de-
vice.
dimensions match those of the de-
vice.
(sound test: an undamaged grind-
ing disc hanging freely on a string
will result in a clear sound if it is
tapped with a plastic hammer).
which is too small to make it
larger.
adapters in order to make grind-
ing discs whose hole is too large
1) helps you to