Inhaltsverzeichnis
Werbung
General application instructions
4
General application instructions
Force transducers are suitable for measuring compressive forces. They
provide highly accurate static and dynamic force measurements and must
therefore be handled very carefully. Particular care must be taken when
transporting and installing the devices. Dropping or knocking the transducer
may cause permanent damage.
The permissible limits for mechanical, electrical and thermal stress are listed in
in section 9 "Specifications" on page 20. It is essential to take these limits into
account when planning the measuring set-up, during installation and,
ultimately, during operation.
The sensor is suitable for checking material testing machines for concrete in
accordance with EN12390 and meets the requirements of DIN 51302-2.
The force transducer also meets the conditions of ISO376, class 0.5 and can
therefore also be used as a reference transducer (transfer measurement
device). With centered load application the sensor can be loaded up to 3 MN.
In this case we recommend using thrust piece ZL (see section 3.2
"Accessories", page 9)
10
KDB
A04785_01_YCI_02 HBM: public
Werbung
Inhaltsverzeichnis
