Attachments On Request - Stiga MJ 66 Gebrauchsanweisung

PROBLEM
7. U neven mowing and poor grass
collection
8. U nusual vibrations while
working
9. T he cutting means do not
engage or do not stop promptly
when they are disengaged
10. U ncertain or ineffective braking
11. E rratic forward movement,
poor drive when going uphill or
if the machine has a tendency
to rear up
12. With the engine running, the
machine does not move when
the drive pedal is pressed
(hydrostatic transmission)
If problems persist after having performed the above operations, contact your dealer.
WARNING! Do not take on complicated repair work without the necessary equipment and
technical knowledge. The guarantee is automatically revoked and the manufacturer declines
all responsibility for any poorly effected repairs.

8. ATTACHMENTS ON REQUEST

8.1 "MULCHING" KIT (Fig. 8.1 no.41)
It chops the grass cuttings finely and leaves
them on the lawn, instead of collecting them in
the grass catcher.
8.2 MAINTENANCE BATTERY CHARGER
(if included) (Fig. 8.1 no.42)
This keeps the battery in good working order
when the machine is in storage, guaranteeing
an optimum level of charge and longer battery
life.
LIKELY CAUSE
– cutting-means assembly is not
parallel to the ground
– inefficient cutting means;
– f orward speed too high
compared to height of grass
– collector channel is blocked
– c utting-means assembly is full
of grass
– t he cutting means are
unbalanced
– the cutting means are loose
– loose bolts and screws
– p roblems with engagement
mechanism
– t he brake is not adjusted
correctly
– p roblems with the belt or the
engagement device
– release lever in position «B»
8.3 CLOTH COVER (Fig. 8.1 no.43)
Protects the machine from dust when not in use.
EN - 17
SOLUTION
– c heck the tyre pressure
(see 5.3.2)
– r einstate the alignment of the
cutting-means assembly in
relation to the ground (see 6.3.1)
– contact your dealer
– r educe the forward speed and/
or raise the cutting-means
assembly (see 5.4.5)
– wait for the grass to dry
– r emove the grass catcher and
empty the collector channel
(see 5.4.7)
– c lean the cutting-means
assembly (see 5.4.10)
– contact your dealer
– contact your dealer
– c heck and tighten all the engine
and frame bolts
– c ontact your dealer
– c ontact your dealer
– c ontact your dealer
– put into position «A» (see 4.23).